8
5. Keep rotary switch (B) depressed for another 10-15 seconds, then release.
6. Check the inspection glass to see whether a flame is burning.
7. Repeat the entire process if the flame has gone out.
8. Use rotary switch (B) to regulate the temperature in the main refrigerator compartment.
2. Automatic ignition
4. Keep rotary switch "B" depressed for another 10-15 seconds, then release.
5. If the flame goes out, the ignition system will repeat the ignition process automatically.
6. Adjust the temperature in the main refrigerator compartment using rotary switch "B".
All refrigerators, whether manual or automatic ignition, are equipped with
automatic flame protection, which automatically cuts off the supply of gas
approximately 30 seconds after the flame goes out.
When using for the first time, and after changing the gas cylinder, the gas
pipes may contain air. By means of brief operation of the refrigerator and
any other gas appliances (e.g. cookers), air is removed from the gas pipes.
The gas will then ignite without delay.
Switching off
1. Set energy
selector switch (A)
to Gas.
2. Press and hold
rotary switch (B).
B
A
3. The ignition process is activated automatically,
accompanied by a ticking sound; the indicator
lamp (D) will flash. Upon successful ignition, the
sound and the flashing will stop.
5.3
1. Set energy selector switch (A) to
position "0" (OFF). The appliance is
now fully switched off.
A
D
Switching off gas operation
If the refrigerator is to be taken out of service for an
extended period of time, the on-board shut-off valve and
the cylinder valve must be closed.
2. Secure the door open by
means of the door stop.
The door will be slightly
ajar; this is to prevent
mould from forming inside
the appliance.
