Bedienungsanleitung Domo DO988RKZ (Seite 25 von 52) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

775725

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

DO988RKZ

www.domo-elektro.be

· Avoid direct sunlight and heat. Direct sunlight may aect the acrylic coating. Heat sources nearby will

cause higher electricity consumption.

· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly on the

evaporator, and your refrigerator.

· Before connecting your refrigerator to the power supply, check that the voltage stated on the rating

label of your appliance corresponds to the voltage in your home. A dierent voltage could damage the

appliance.

· The appliance must be grounded. The manufacturer is not responsible for damages that may occur as

a result of usage without grounding.

· After installation, leave the freezer for 8 hours before turning it on. This way the refrigerant can settle.

· Allow the appliance to run empty for 24 hours so the compartment can cool to the appropriate

temperature.

· This appliance is designed to operate in ambient temperature between 16°C and 38°C. If these

temperatures are exceeded, i.e. colder or warmer, the appliance will not operate correctly.

· The appliance may only be used indoors.

USE

TEMPERATURE CONTROL

The fridge is controlled with a temperature control knob located inside the

appliance.

Adjust the control knob as desired to suit your individual preference.

· COLDER: 0-4°C

· NORMAL: 4-7°C

· COLD: 7-10°C

· OFF

· The running time and temperature are aected by where the freezer is located, how often the door is

opened and the temperature of the room the freezer is located in.

· When you use the appliance for the rst time or after defrosting, adjust the control knob to the coldest

setting for at least 2 hours before introducing food to be stored, and then readjust to the middle

setting.

MOVING YOUR APPLIANCE

If the appliance is turned o for any reason, wait for 10 minutes before turning it back on. This will allow

the refrigeration system pressures to equalise before restarting.

· Turn o the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile

parts (shelves, accessories, etc.) or x them into the fridge to avoid any shock.

· Relocate and install. If the appliance has been left on its side for any length of time, leave it standing

upright for at least 10 minutes before turning on.

Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly

and natural gas, it is explosive. Therefore you should be careful during shipment and installation to

prevent your appliance’s cooler elements from being damaged. In the event of a leak caused by damage

to the cooler elements, move your fridge from open ame or heat sources and ventilate the room where

the appliance is located for a few minutes.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Domo DO988RKZ Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info