Bedienungsanleitung Dovre 2510SD (Seite 64 von 253) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

571606

Zoom out

Zoom in

Vorherige Seite

1/253

Nächste Seite

Tar and creosote are highly combustible sub-

stances. Thicker layers of these substances

may catch fire if the temperature in the chim-

ney increases suddenly. By allowing the fire to

burn very intensely regularly, layers of tar and

creosote will disappear.

Low intensity fires also cause tar deposits on

the stove window and door.

When the outside temperature is not very low,

it is better to burn wood intensely for a few

hours instead of having a low intensity fire for a

long period of time.

Control the air supply with the secondary air inlet.

The secondary air inlet not only supplies air to

the fire but to the glass as well, so that it does

not quickly become dirty.

Open the primary air inlet for the time being if the air

supply by the secondary air inlet is inadequate or if

you want to fan the fire.

It is better to add a small amount of logs regularly

than to add many logs at the same time.

Regularly adding small amounts of brown coal bri-

quettes or anthracite coal is better than adding a

large amount of brown coal briquettes or anthracite

coal in one go.

Extinguishing the fire

Do not add fuel and just let the fire go out. If a fire is

damped down by reducing the air supply, harmful sub-

stances will be released. For this reason, the fire

should be allowed to go out naturally. Keep an eye on

the fire until it has gone out. All air inlets can be closed

once the fire has died completely.

Removing ash

After wood has burnt, a relatively small amount of ash

is left over. This ash bed is a good insulating layer for

the stove base plate and improves combustion. It is

good idea to leave a thin layer of ash on the stove

base plate.

After brown coal briquettes and anthracite coal have

burnt, a relatively large amount of ash is left over.

Remove the excess ash regularly.

The ash should never reach the bottom of the

grate. This will cause the grate to overheat and

be damaged.

The flow of air through the fire plate must not be

obstructed, and ash must not be allowed to accu-

mulate behind an inner plate. Remove the excess ash

regularly.

1. Open the door of the appliance.

2. Use the riddling rod to make the ash drop through

the grate into the ash pan.

3. Using the cold handle glove supplied, remove the

ash pan and empty it; see the next two figures.

4. Replace the ash pan and close the door of the

appliance.

Fog and mist

Fog and mist hinder the flow of flue gases through the

flue. Smoke can blow back and cause a stench. If it is

not strictly necessary, it is better not to use the stove

in foggy and misty weather.

Solving problems

Refer to the appendix "Diagnostic diagram" to resolve

any problems in using the stove.

Subject to change because of technical improvements

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dovre 2510SD Seite 64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info