Bedienungsanleitung Dovre 325CB (Seite 31 von 133) (Deutsch, Englisch, Holländisch, Französisch, Spanisch, Norwegisch)

745852

Zoom out

Zoom in

Vorherige Seite

1/133

Nächste Seite

3. In the case of connection to outside air: connect

the outside air supply to the connector fitted to the

appliance.

4. Re-position all removed parts in the correct places

in the stove.

Never light a fire in the appliance without the

fireproof inner plates.

The appliance is now ready for use.

Use

First use

When you use the stove for the first time, make an

intense fire and keep it going for a good few hours.

This will cure the heat-resistant paint finish. This may

result in some smoke and odours. You could open

windows and doors for a while in the area in which the

stove is located.

Fuel

This stove is only suitable for burning natural wood;

sawn and chopped wood that is sufficiently dry.

Do not use other fuels, as they can cause serious

damage to the stove.

You are not allowed to use the following fuels, as they

pollute the environment and because they heavily soil

the appliance and flue, which may lead to a chimney

fire:

Treated wood, such as scrap wood, painted wood,

impregnated wood, preserved wood, plywood and

chipboard.

Plastics, scrap paper and domestic waste.

Wood

Hardwood, such as oak, beech, birch and fruit tree

wood is the ideal fuel for your stove. This type of

wood burns slowly with calm flames. Softwood

contains more resins, burns faster and sparks

more.

Use seasoned wood that contains no more than

20% moisture. The wood should have been

seasoned for at least 2 years.

Saw the wood to size and split it while it is still

fresh. Fresh wood is easier to split, and split wood

dries more easily. Store the wood under a roof

where the wind has free access.

Do not use damp wood. Damp logs do not produce

heat as all the energy is used in the evaporation of

moisture. This will result in a lot of smoke and soot

deposits on the stove door and in the chimney. The

water vapour will condense in the stove and can

leak away through chinks in the stove, causing

black stains on the floor. It may also condense in

the chimney and form creosote. Creosote is a

highly flammable compound and may cause a

chimney fire.

Lighting

You can check whether the flue has sufficient draught

by lighting a ball of paper above the baffle plate. A cold

flue often has insufficient draught and consequently,

some smoke may escape into the room instead of up

the chimney. You can avoid this problem by lighting

the fire as described below.

1. Stack two layers of medium sized logs crosswise.

2. Stack two layers of kindling crosswise on top of

the logs.

3. Place a firelighter cube in the lower layer of

kindling and light the cube according to the

instructions on the packaging.

4. Close the door of the appliance and open the

primary air inlet and the secondary air inlet of the

Subject to change because of technical improvements 9

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dovre 325CB Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info