Bedienungsanleitung Dovre Bow-WB (Seite 35 von 161) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Norwegisch)

695911

Zoom out

Zoom in

Vorherige Seite

1/161

Nächste Seite

Subject to change because of technical improvements

suddenly. By allowing the fire to burn very

intensely regularly, layers of tar and creosote

will disappear.

Low intensity fires can also cause tar deposits

on the stove window and door.

When the outside temperature is mild, it is bet-

ter to burn wood intensely for a few hours

instead of having a low intensity fire for a long

period of time.

Control the air supply using the air vent.

The air inlet not only supplies air to the fire but

to the glass as well, so that it does not quickly

become dirty.

Open the primary air inlet for the time being if the air

supply by the secondary air inlet is inadequate or if

you want to fan the fire.

Topping up with a few logs regularly is better than

adding many logs in one go.

Extinguishing the fire

Do not add fuel and just let the fire go out. If a fire is

damped down by reducing the air supply, harmful sub-

stances will be released. For this reason, the fire

should be allowed to go out naturally. Keep an eye on

the fire until it has gone out. All air inlets can be closed

once the fire has died completely.

Removing ash

After wood has been burnt, a relatively small amount

of ash remains. This ash bed is a good insulating layer

for the stove base plate and improves combustion. It

is a good idea to leave a thin layer of ash on the stove

base plate.

The flow of air through the fire plate must not be

obstructed, however, and no ash may be allowed to

accumulate behind a cast-iron inner plate. Remove

the excess ash regularly.

1. Open the door of the appliance.

2. Use the scraper (1) supplied to scrape the excess

ash through the openings into the ash pan.

3. Using the glove supplied, remove the ash pan and

empty it.

4. Replace the ash pan and close the door of the

appliance.

09-20021-181

Fog and mist

Fog and mist hinder the flow of flue gases through the

flue. Smoke can blow back and cause a stench. If it is

not strictly necessary, it is better not to use the stove

in foggy and misty weather.

Resolving problems

Refer to the appendix "Diagnostic diagram" to resolve

any problems in using the appliance.

Maintenance

Follow the maintenance instructions in this chapter to

keep the appliance in good condition.

Chimney (flue)

In many countries, you are required by law to have

your chimney checked and maintained.

At the start of the heating season: have the chim-

ney swept by a recognised chimney sweep.

During the heating season and after the chimney

has not been used for a long time: have the chim-

ney checked for soot.

At the end of the heating season: close off the chim-

ney and plug with newspaper.

Cleaning and other regularly

maintenance

Do not clean the appliance when it is still

warm.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dovre Bow-WB Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info