Bedienungsanleitung Dovre TAI 45C (Seite 44 von 223) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

571252

Zoom out

Zoom in

Vorherige Seite

1/223

Nächste Seite

Safety

Please note: All safety regulations must be

complied with strictly.

Please read carefully the instructions supplied

with the appliance for installation, use and

maintenance before using the appliance.

The appliance must be installed in accordance

with the legislation and requirements applic-

able in your country.

All local regulations and the regulations relating

to national and European standards must be

observed when installing the appliance.

The appliance should preferably be installed by

an authorised installer. Installers will be aware

of the applicable regulations and requirements.

The appliance is designed for heating pur-

poses. All surfaces, including the glass and

connecting tube, can become very hot (over

100°C)! When operating, use a so-called "cold

hand" or an oven glove.

Ensure that there is adequate screening if

young children, disabled people, the elderly or

animals are present in the vicinity of the appli-

ance.

Safety distances from flammable materials

must be strictly adhered to.

Do not place any curtains, clothes, laundry or

other combustible materials on or near the appli-

ance.

When in use, do not use flammable or explos-

ive substances in the vicinity of the appliance.

Avoid chimney fires by having the chimney

swept regularly. Never burn wood with the door

open.

In the event of a chimney fire: close all the

appliance's air inlets and alert the fire service.

If the glass in the appliance is broken or

cracked, it must be replaced before you can

use the appliance again.

Ensure that there is adequate ventilation in the

room in which the appliance is installed. If vent-

ilation is insufficient, combustion will be

incomplete whereby in toxic gases can spread

through the room. See the chapter "Installation

requirements" for more information on vent-

ilation.

Installation

requirements

General

The appliance must be connected tightly to a well-

functioning flue.

For connection measurements: see "Technical

data" appendix.

Ask the fire service and/or your insurance com-

pany about any specific requirements and reg-

ulations.

Flue

The flue is needed for:

Removal of combustion gases via natural draught.

As the warm air in the flue or chimney is lighter

than the outside air, it rises.

Air intake, needed for the combustion of fuel in the

appliance.

A poorly-functioning flue or chimney can cause smoke

to escape into the room when the door is opened.

Damage caused by smoke emissions into the room is

not covered by the warranty.

Do not connect multiple appliances (such as a

boiler for central heating) to the same flue,

unless local or national regulations allow this.

In the event of two connections ensure that the

difference in height between the connections is

no less than 200 mm.

Ask your installer for advice regarding the flue. Refer

to the European norm EN13384 for a correct cal-

culations for the flue.

The flue must satisfy the following requirements:

The flue or chimney must be made of fire-resistant

material, preferably ceramics or stainless steel.

Subject to change because of technical improvements

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dovre TAI 45C Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info