Bedienungsanleitung Dovre TAI 55C (Seite 49 von 224) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Norwegisch)

695931

Zoom out

Zoom in

Vorherige Seite

1/224

Nächste Seite

seasoned for at least 2 years. Wood with a mois-

ture content of 20% provides 4.2 kWh per kg wood.

Wood with a moisture content of 15% provides 4.4

kWh per kg wood. Freshly felled wood has a mois-

ture content of 60% and only provides 1.6 kWh per

kg wood.

Saw the wood to size and split it while it is still

fresh. Fresh wood is easier to split, and split wood

dries more easily. Store the wood under a roof

where the wind has free access.

Do not use damp wood. Damp logs do not produce

heat as all the energy is used in the evaporation of

moisture. This will result in a lot of smoke and soot

deposits on the appliance door and in the flue. The

water vapour will condense in the appliance and

can leak away through chinks in the stove, causing

black stains on the floor. It may also condense in

the chimney and form creosote. Creosote is a

highly flammable compound and may cause a chim-

ney fire.

Brown coal briquettes

Brown coal briquettes have approximately the same

burning characteristics as wood.

Ensure there is a good charcoal bed before you

start burning brown coal briquettes.

For lighting the fireplace, follow the instructions in

the "Lighting" paragraph.

Anthracite coal

Anthracite coal is divided into various categories on

the basis of characteristics, sometimes specified by

law, such as the percentage of volatile compounds.

The ash content of anthracite coal is between 3% and

13%. The lower the ash content, the higher the net

heating value and the less often you have to remove

ash.

Preferably use category A anthracite coal with a

low ash content.

Use the recommended size 12/22 or 20/30.

For lighting the fireplace, follow the instructions in

the "Lighting" paragraph.

Lighting

You can check whether the flue has sufficient draught

by lighting a ball of paper above the baffle plate. A cold

flue often has insufficient draught and consequently,

some smoke may escape into the room instead of up

the chimney. You can avoid this problem by lighting

the fire as described below.

1. Stack two layers of medium sized logs crosswise.

2. Stack two to three layers of kindling crosswise on

top of the logs.

3. Place a firelighter between the bottom layer of kind-

ling and light the firelighter according to the instruc-

tions on the packaging.

09-20500-016

4. Close the door of the appliance and open the

primary and secondary air inlets by completely

opening the primary and secondary air sliders; see

the following figure. If there is inadequate draw,

the ash pan can be set at a small tilt for some

time.

5. Let the fire develop into a good blaze until there is

a glowing bed of charcoal. After this, you can add

more fuel and adjust the appliance; see the sec-

tions on "Burning wood", "Burning brown coal bri-

quettes (for TAI M only)" and "Burning anthracite

coals (for TAI M and TAI C)" .

Subject to change because of technical improvements

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dovre TAI 55C Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info