Bedienungsanleitung Dovre ZEN 100 (Seite 41 von 183) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Norwegisch)

571589

Zoom out

Zoom in

Vorherige Seite

1/183

Nächste Seite

09-20020-306

Pos-

ition

Description

Primary air open (when lighting the stove)

Secondary air open (afterburning)

Glass rinse open

Secondary air open (afterburning)

Glass rinse open

Minimum secondary air inlet open (after-

burning)

Advice

Never burn wood with an open door.

Stoke the appliance regularly and thoroughly.

If you frequently burn at a low setting, tar and

creosote may be deposited in the flue. Tar and

creosote are highly combustible substances.

Thicker layers of these substances may catch

fire if the temperature in the flue increases sud-

denly. By burning the fire at a high intensity on

a regular basis, any layers of tar and creosote

will disappear.

Burning at a low intensity can also cause tar to

be deposited on the appliance window and

door.

When the outside temperature is mild, it is bet-

ter to burn wood intensely for a few hours

instead of having a low intensity fire for a long

period of time.

Control the air supply using the air vent.

The air inlet not only supplies air to the fire but

to the glass as well, so that it does not quickly

become dirty.

Open the primary air inlet for the time being if the air

supply by the secondary air inlet is inadequate or if

you want to fan the fire.

Topping up with a few logs regularly is better than

adding many logs in one go.

Extinguishing the fire

Do not add fuel and just let the fire go out. If a fire is

damped down by reducing the air supply, harmful sub-

stances will be released. For this reason, the fire

should be allowed to go out naturally. Keep an eye on

the fire until it has gone out. All air inlets can be closed

once the fire has died completely.

Removing ash

After wood has been burnt, a relatively small amount

of ash remains. This ash bed is a good insulating layer

for the stove base plate and improves combustion. It

is a good idea to leave a thin layer of ash on the stove

base plate.

The flow of air through the stove base plate must not

be obstructed. Remove the excess ash regularly.

1. Open the door of the appliance.

2. Scoop the excess ash from the appliance or use a

special ash vacuum cleaner to remove the excess

ash.

Always use an ash vacuum cleaner; using an

ordinary vacuum cleaner that has not been spe-

cially modified can cause serious damage to

an ordinary vacuum cleaner.

3. Close the door of the appliance.

Fog and mist

Fog and mist hinder the flow of flue gases through the

flue. Smoke can blow back and cause a stench. If it is

not strictly necessary, it is better not to use the stove

in foggy and misty weather.

Resolving problems

Refer to the appendix "Diagnostic diagram" to resolve

any problems in using the appliance.

Subject to change because of technical improvements

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dovre ZEN 100 Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info