680255
20
Zoom out
Zoom in
Vorherige Seite
1/129
Nächste Seite
2-4
Installation & Setup
2.2 Hardware Installation
2.2.1 Connecting the Power Adapter
1. Connect the power adapter to the power outlet on the wall and to
the PWR power jack on the rear panel of the router.
2. The ACT LED should be blinking once every 2 seconds.
2.2.2 Connecting to the Ethernet
A. Connecting to PCs:
1. Attach the Ethernet cable (blue color cable) to any P1 ~ P6
port.
2. Connect the other end of the Ethernet cable to your PCs'
installed network interface card (NIC).
3. The LED indicators at both the Ethernet port and the NIC
should be ON.
4. Attach the Console cable to Console port.
5. Connect the other end of the Console cable to the
Management PC (p6~p23) you want to use to configure the
Vigor2000 Router.
Note:
If the Ethernet cable is not long enough to reach your PCs,
purchase a longer straight-through CAT. 5 UTP or STP
Ethernet cable.
B. Connecting to an External Ethernet Hub:
1. Attach the Ethernet cable (blue color cable) to the Uplink
port.
2. Connect the other end of the Ethernet cable to the external
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Draytek Vigor 2000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info