Bedienungsanleitung Drive PowerStroll (Seite 17 von 44) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

801304

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Instructions for use POWERSTROLL

Drive Medical GmbH & Co. KG | As per: 04.05.2021 | Errors and alterations excepted

Disassembly and transport

1. Switch o the PowerStroll and unplug the cable at

the control panel.

2. Remove the relief strap from the push handle.

3. To release the battery, press the gray PUSH but-

ton on the power unit (photo 16). Then pull out the

battery.

4. Remove the power unit. To do this, pull the black

band between the holders upwards and at the same

time, take the power unit out of the holder from the

back (see image below).

5. Stow all parts in the carrying bag provided.

Note

The battery supplied with the PowerStroll meets IATA

special provision A67 and is approved for transport in an

airplane. Nonetheless, if you have any questions in this

regard, consult your airline prior to travel.

Cleaning | Maintenance

• Clean regularly with a moist cloth!

• Do not use any aggressive cleaning agents!

• Do not use abrasive cleaners!

• Do not use any high-dose chlorine and vinegar-based

cleaners!

• To disinfect, a spray disinfectant can be used such as

Descosept AF or Bacillol AF.

• Check the screws regularly and tighten, if necessary.

• The product must not be continuously exposed to tem-

peratures over 60°C.

• In the event of defects, contact your specialist dealer

from whom you purchased this product.

• Do not use any petroleum ether, solutions or evapora-

ting solutions since these could damage plastic parts.

Do not use any wax.

• Ensure that the charging unit was unplugged and that

the PowerStroll is switched o before you clean it.

• Check the condition of the tires regularly. They are

"fail-safe," meaning that you do not have to check air

pressure or ﬁll them with air. Always check the tires for

tears or other damage, however.

Troubleshooting

The wheelchair does not move although the lever is

squeezed:

• Check whether the PowerStroll is switched on.

• Check whether the battery is fully charged.

• Check whether the connection between the battery

and motor is correct.

• Check whether the brakes of the wheelchair are

released.

• Check whether the drive wheel is in contact with the

ground.

• It is dicult to move the wheelchair by hand:

• Check whether the brakes of the wheelchair are

released.

• • Raise the PowerStroll.

Warranty conditions

There is a comprehensive warranty for a period of two

years (except for parts subject to wear; 6 months for the

battery) starting from the date of delivery of your new Po-

werStroll. The warranty includes the replacement parts

of the PowerStroll during this period.

Technical data

PowerStroll PowerStroll HD

Article number PWCPP011 PWCPP011HD

HMV (medical

aids register) no. 18.99.04.1024

Overall width 25 cm 25 cm

Overall length 41 cm 41 cm

Speed 6 km/h 6 km/h

Battery

capacity 2x 12 Ah 12 Ah

Motor output 150 W 200 W

Climbing ability 10,5 % 10,5 %

Total weight 19,9 kg 19,9 kg

Weight of battery 9,7 kg 9,7 kg

Weight without

battery 10,2 kg 10,2 kg

Max. load 135 kg 180 kg

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Drive PowerStroll Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info