Bedienungsanleitung DRU ART 4-01 (Seite 16 von 56) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

810299

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

GENERAL NOTES

Art 2-01,3-01 and 4-01 on propane (G31) can

be placed in vehicles pulling mobile units, pro-

vided the following is observed:

• When the appliance is working, the mobile unit must be

standing still;

• When the vehicle pulling the mobile unit is being filled

with fuel, the appliance must be switched off;

• If glass is broken, switch off the appliance and contact an

installer;

• In case of a gas leak, switch off the appliance as well as the

gas supply tap and contact an installer;

• Flue gas discharge must remain unobstructed at all times.

Gas Safety Regulations (for installation & use) 1998

In your own interest and that of safety, it is law that all gas

appliances are installed by competent persons in accor-

dance with the above regulations. Failure to install appli-

ances correctly could lead to prosecution.

NB: The Confederation of Registered Gas Installers,

whose members are identified by the emblem shown here,

are all required to work to the recognised standards.

Cleaning and Maintenance

The appliance should be inspected once a year by a quali-

fied company, and cleaned and/or repaired as necessary.

The inspection and maintenance must at least ensure that

the appliance is working correctly and safely. This can be

done by your own gasinstaller or a specialised mainte-

nance company. It is advisable to remove any dust from

the appliance several times before and during the heating

season. Do not use corrosive or abrasive substances to

clean the casing. Any damage to the coating, caused by

things put on or against the casing for example, is not cov-

ered by the guarantee.

NB: When replacing the pilot light burner, the coupling

nut in the gas control block should first be tightened by

hand and then tightened a quarter-turn with an

open-ended spanner.

Discoloration of walls and ceiling

Brown discoloration is an annoying problem, which is dif-

ficult to solve. It can be caused by dust burning as a result

of poor ventilation, for example, or by cigarette smoke or

candles.

These problems can be avoided by ensuring that the room

the heater is in is properly ventilated. A good guideline for

ventilation is:

New buildings : 3.24 m3 / hour per m2 floor

surface of the room.

Existing buildings : 25.20 m3 / hour for a room.

Use candles and oil lamps as little as possible, keeping the

wick as short as possible. While they enhance the atmo-

sphere, candles and oil lamps also cause the formation of

large quantities of unhealthy soot particles in your home.

Cigarette and cigar smoke contains tar, which upon heat-

ing will precipitate on cold or damp walls. If you have a

newly cemented chimney or have had any other recon-

structions / renovations done, you are advised to wait at

least 6 weeks before lighting your fire, to allow the walls,

floor and ceiling to dry out completely.

Lighting the heater for the first time

There can be an unpleasant smell when you light the heat-

er for the first time. This is caused by the varnish evapo-

rating and will disappear after a few hours. We therefore

advise you, on initial use, to heat the appliance at the high-

est setting while ventilating the room it is installed in well.

Extra protection

This heater meets the normal safety standards regarding

surface temperatures, but physical contact with heated

surfaces should be avoided where possible. An additional

guard is recommended to protect young children and

elderly, infirmed or handicapped people.

End of life / Recycling

At the end of the use cycle, the device must be disposed

of and recycled in a responsible manner. Local laws and

regulations must always be followed when disposing/recycling

the appliance. If in doubt, contact the local government

about the available collection flows.

Disassemble and remove the device when it has cooled

down to room temperature. Pay attention! The glass in the

appliance (if applicable) is made of ceramic heat-resistant

material and therefore cannot be returned to a glass

recycling point.

Guarantee

The warranty for your DRU appliance will be provided by

your supplier. In case of malfunctions, you should always

contact him. You supplier will contact DRU if he feels this

is necessary. The factory warranty for your appliance is

valid for 2 years after date of purchase.

GENERAL NOTES

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DRU ART 4-01 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info