651047
8
Zoom out
Zoom in
Vorherige Seite
1/19
Nächste Seite
Code Rev. D 20140818 (IEC)
8
guarantee the required safety of the appliance (e.g.
danger of overheating).
The appliance must not be connected to an inverter
and must not be used with a plug adapter as these
can cause damage to the appliance’s electronic unit.
The cord must rest securely behind the appliance
and not be allowed to lie or hang unprotected.
WARNING:
THIS APPLIANCE MUST BE EARTHED.
INSTALLING THE HANDLE
IMPORTANT: Do not overtighten the screws & do
not use power tools to install the handle.
DESIGN 1
1
2
3
Locate the handle
,1 over the fixing pins
,3 of
the door and using the supplied allen key, tighten
the securing grub screws
,2 to fix the handle.
DESIGN 2
1
2
3
4
5
1. Remove the door gasket
,1 on the side you
wish to install the handle - you can see two
designated holes for handle installation.
2. Install the handle
,4 tightly as shown above
with two screws
,3 and flat washers
,2
provided.
3. Replace the door gasket.
REVERSING THE DOOR HINGE
It is possible to reverse the door on this appliance, if
required.
To do so, follow the steps below:
DESIGN 1 For built-under models
1. Remove the ventilation grille
,2 and the
adjustable ventilation grille
,1 by unscrewing
the screws
,3 &
,4. (Fig. 1)
NOTE: For some models without adjustable
ventilation grille, the step is not needed.
2. Remove the bottom hinge
,5 by unscrewing
the four lock screws
,6. Be careful to hold
the glass door firmly after removing the screws.
(Fig. 2)
3. Gently pull down to remove the glass door
from the right top hinge and place it on a
padded surface to avoid the risk of damage.
Then remove the right top hinge
,9. (Fig. 4)
4. Unscrew and transfer hinge pin
,7 and/or
door stopper
,8of the bottom hinge to the
opposite side. (Fig. 3)
5. Pop out the cover caps on the left side of
cabinet and use them to cover the screw holes
on the right hand side.
6. Screw the alternative left top hinge
,11,
included in the fittings, on the left hand side of
cabinet. (Fig. 4)
7. Unscrew and transfer the holes cover
,12
and lock catch
,13 to the opposite side of
glass door. (Only for models with lock on the
ventilation grille) (Fig. 5)
8. Rotate the door 180° (No need for models with
Note: All parts removed must be saved to
do the reinstallation of door.
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Dunavox DAU-17.57DB wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info