35291

Durabrand CD2158 Anleitung

1
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
- 1 - - 2 - - 3 -
- 4 - - 5 - - 6 -
PARTS OF LOCATION
CD door
REPEAT/
SKIP/SEARCH
buttons
POWER indicator
DISC SKIP button
REPEAT indicators
(ONE SONG/ONE DISC/ALL DISC)
PHONES jack
FUNCTION selector
(
STANDBY/TUNER/CD)
CD storage door
BAND selector (AM/FM)
VOLUME control
Dial scale
TUNING control
Remote sensor
CD STOP
/PLAY/PAUSE
buttons
CD display
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
1. Slide the FUNCTION selector to
TUNER. The POWER indicator lights
up.
2. Slide the BAND selector to desired
band.
3. Tune into a station.
4. Adjust the volume level.
RADIO OPERATION
NOTE: DO NOT CONNECT TO AN OUTSIDE ANTENNA.
Fully unwind the wire antenna. Then
extend the wire antenna and place it
in the position that sounds best.
(When the FM broadcast signal is fine,
it can receive FM Stereo Broadcast.)
Rotate the unit to get the best receiving
position.
AFTER LISTENING
Slide the FUNCTION selector to STANDBY.
FOR BETTER RECEPTION
STANDBY
TUNER
FUNCTION
CD
BAND
AM FM
TUNING
VOLUME
1
. SPEAKERS CONNECTING
Connect the wires to the speaker terminals in correct position.
Note: Connecting speakers other than the speakers supplied with the unit, may
damage the unit.
2
. AC POWER CONNECTING
Before use, check that the rated voltage of your unit matches your local voltage.
Make sure both speakers are connected correctly before plugging the AC power
cord into an AC outlet.
Caution: To prevent electrical shock, wide blade of plug to wide slot, fully insert.
(For USA and Canada)
To an AC outlet
FCC INFORMATION (For USA only)
This device complies with Part 15 of FCC Rules. Operations are subject to the follow-
ing two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that
may cause undesirable operations.
Complies with the Canadian ICES-003 class B specification.
Should any trouble occur, disconnect the AC power cord and refer servicing to
qualified personnel.
SYSTEM CONNECTIONS
COMPACT DISC PLAYBACK
5. Close the CD door by holding down on its center until secure. The total number of
tracks will show in the CD display for a few seconds.
1. Slide the FUNCTION selector to CD.
The POWER indicator lights up.
2. Open the disc compartment.
3. Place a disc onto the disc(s) holder,
with the label side up.
Caution: The unit can play 5 inch
(12cm) only.
4. Press the DISC SKIP button to revolve
the tray clockwise.
Place other disc(s) on the disc holder(s).
6. Press the DISC SKIP button to select the desired disc. Press either one of the
SKIP/SEARCH
buttons to select the desired track.
STANDBY
TUNER
FUNCTION
CD
SKIP/SEARCH
DISC SKIP
2
DISC
TRACK
8
DISC SKIP
Protect the power cord from being walked on or pinch particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
Only use attachments/accessories specified by the manufacturer.
Unplug this apparatus during lightening storms or when unused for long periods of
time.
Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
This appliance shall not be exposed to dripping or splashing water and that no
object filled with liquid such as vases shall be placed on the apparatus.
This product contains a low
power laser device.
10)
11)
12)
13)
14)
Follow the advice below for safe and appropriate operations.
ON PLACEMENT
· Do not use the unit in places which are extremely hot ,cold ,dusty, or humid.
· Place the unit on a flat and even surface.
· Do not restrict the air flow of the unit by placing it in a place with poor air flow, by
covering it with a cloth, or by placing it on a carpet.
ON SAFETY
· When connecting and disconnecting the AC cord, grip the plug and not the cord itself.
Pulling the cord may damage it and create a hazard.
· When you are not going to use the unit for a long period of time, disconnect the AC
power cord.
ON CONDENSATION
· When left in a heated room where it is warm and damp, water droplets or condensation
may form inside the CD player.
· When there is condensation inside the unit, the unit may not function normally.
· Let it stand for 1 to 2 hours before turning the power on , or gradually heat the room up
and dry the unit before use.
CLASS 1
LASER
PRODUCT
CAUTION
INVISIBLE LASER RADIATION WHEN
OPEN AND INTERLOCKS DEFEATED.
AVOID EXPOSURE TO BEAM.
PRECAUTIONS
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES
CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
CAUTION: TO REDUCE
THE RISK OF ELECTRIC
SHOCK, DO NOT
REMOVE COVER (OR
BACK) NO USER-
SERVICEABLE PARTS
INSIDE. REFER
SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
The exclamation point
within an equilateral
triangle is intended to
alert the user to the
presence of important
operating and
maintenance (servicing)
instructions in the
literature accompanying
the appliance.
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the manufacturer's
instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including
amplifiers) that produce heat.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong are provided
for your safety. If the provided plug does not fit into your outlet , consult an electrician
for replacement of the obsolete outlet.
IMPORTANT SAFETY INSTRUCTIONS
CAUTION
The lightning flash with
arrowhead symbol, within
an equilateral triangle, is
intended to alert the user
to the presence of
uninsulated "dangerous
voltage" within the
product's enclosure that
may be of sufficient
magnitude to constitute a
risk of electric shock to
persons.
WARNING
1)
2)
3)
4)
5)
6)
7)
8)
9)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Durabrand CD2158 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info