Bedienungsanleitung Duronic HV120 (Seite 4 von 23) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

650091

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

6 7

General Safety Assembly

Electrical Safety

To Use

- Do not cover, restrict the air inlet/outlet or use the appliance to dry clothes.

- Do not use without feet attached.

- Only use in the upright position on a at level surface.

- Make sure that children and pets are closely supervised when the heater is

in use.

- Do not use the appliance near ammable or heat sensitive items

- Do not position directly next to power sockets, shelving or other obstructions

to airow.

- Do not use the heater in the immediate surroundings of a bath, a shower, or

a swimming pool.

- This appliance is not intended for use by persons (including children)

with reduced physical, sensory or metal capabilities, or lack of experience

and knowledge, unless they have been given supervisions or instruction

concerning use of the appliance by a person responsible for the safety.

NOTE

- For maximum benet, close windows and doors when the heater is in use.

- Do not cover the ventilation holes as this will cause overheating and will

activate the cut out.

- Carefully turn the radiator on it’s side to t the feet

- Position each foot as shown in g1. and secure using the self tapping screws

provided

- Two screws are required for each foot and this unit must not be used without

the feet rmly attached.

- Turn the heater to the “OFF” position before plugging in.

- The operating temperature is selected by a combination of the heater

switches and thermostat. The hottest setting will be when the heater switches

are both on and the thermostat is turned to “Maximum”.

- To determine the correct working temperature for your conditions, turn the

heater to “High” and the thermostat to “Maximum” when the room has reached

the required temperature turn the thermostat slowly to the left until the

temperature is off. The temperature will now be kept constant.

- If you want to lower the operating temperature select the heater switch only

and repeat the above procedure.

- The heater is tted with an automatic cutout in the event that it overheats.

If this activates, turn the heater to the off position and unplug. Allow the

heater to cool and remove anything restricting the airow before using the

heater again. If the automatic cut out operates repeatedly contact a quantied

electrician for advice.

- For indoor use only.

- Switch off and unplug when not in use.

- Do not use if the cord is damaged.

- No not use heater in humid or wet environments

- If the appliance cord is damaged, it must be replaced by an electrician or

similarly quality person to avoid hazard.

Thermostat

Fan Switch

||: 1250W

|: 750W

DO NOT plug the heater into an extension lead or adapter as the heater is too

powerful. Using an extension lead or adapter with the heater is a fire hazard and

may cause damage to the device the the user.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Duronic HV120 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info