Bedienungsanleitung Duux DXAW03 (Seite 5 von 39) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

732845

Zoom out

Zoom in

Vorherige Seite

1/39

Nächste Seite

can set the hygrostat in the range between 40%

and 70%. With every touch it will increase with 10%

in the following order: 40% > 50% > 60% > 70%

> CO (continuous). Using continuous mode will

deactivate the hygrostat and the device will run

at continuous speed. When the hygrostat is set

above the actual humidity, the device will operate

in high speed until the desired humidity has been

reached. When the hygrostat is set below the

actual humidity, the device will not humidify. After

setting the hygrostat, the display will show the

ambient humidity.

Timer

Press the button to activate the timer setting.

With every touch the timer will increase with one

hour in the following sequence: 1h > 2h > 3h > 4h

> 5h > 6h > 7h > 8h > 9h > 10h > 11h > 12h

> 00h (o). Once the timer is activated, the device

will automatically shut down after the set timer has

been completed.

Night mode

Press the button to activate night mode. Once

pressed, the LED matrix display will show “ZZZ” for

5 seconds. In night mode, all buttons are disabled

except the night mode and power button. The

device will operate in SL (slow) speed mode.

Power

Touch the button to switch on the device.

After turning on the device, the LED matrix display

will light up for 1 second and shows “Hi!” for 2

seconds after which it will display the current

status followed by the ambient humidity. When

you turn on the device for the rst time, it will

activate medium wind speed and turn to low

wind speed after 3 seconds. The humidication

setting will remain active. Touch the POWER button

again to put the device in stand by followed by a

conformation beep. The LED matrix will show “OFF”

and turn o the device in 2 seconds.

Humidity output / wind

speed

When you turn on the device for the rst time,

it will activate medium wind speed. Touch the

button to switch between wind speeds. The LED

matrix display will show the corresponding wind

speed in SL (slow), LO (low), MI (medium) and HI

(high).

Hygrostat

Touch the button to set the desired ambient

humidity. When you turn on the device for the rst

time, the continuous mode will be activated. You

Press the button again to deactivate night

mode. The LED matrix display will show “ZZZ”

and go back into normal operation mode according

to the hygrostat setting.

Dry run protection

After turning on the device it will check for 1

second if there is sucient water remaining in the

water tank. In case of lack of water, the device will

activate dry run protection mode and the motor

will stop working. The LED matrix display will show

“NO!” and “Lo” alternating every second. In this

mode, all buttons are disabled except the power

button. Please turn o the device, ll the water

tank and press the power button to switch on the

device again.

Note: It may take a couple of seconds before

the water from the water tank lls up the water

tray. You will hear a water dripping sound, which is

normal. Once the device has recognized the water

tray is lled, it will start operating.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Duux DXAW03 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info