Bedienungsanleitung Dyson Airblade 9kJ (Seite 5 von 252) (Alle Sprachen)

761234

Zoom out

Zoom in

Vorherige Seite

1/252

Nächste Seite

Looking after your

hand dryer

Please register as a Dyson

hand dryer owner

To help us ensure you receive a prompt and

efficient service, please register your machine

at www.dyson.com/airblade. This will

of your Dyson machine in the event of an

insurance loss, and enable us to contact you

if necessary.

You will need your serial number, which can

be found on the rating plate inside the main

body and on the information sticker on the

front of the machine.

Please ensure all instructions and guidance in

the Installation instructions and Maintenance

manual are adhered to or your guarantee

may be invalidated.

Maintenance

How to use

Place your hands beneath the Dyson

Airblade™ hand dryer arms and it will start

automatically, creating sheets of air that

scrape water from your hands.

For best dry time results:

Keep your hands flat and parallel to the

machine's surface, approximately 5mm from

the air aperture, drawing your hands through

the airflow from your wrists to finger tips.

Move your hands slowly through the airflow,

keeping a consistent speed (approx.

2.5 seconds per side), alternating between

front and back each time.

Keep your hands flat, close the gaps between

your fingers and keep your thumbs tucked in,

so the whole of your hand is drawn through

the airflow.

For more information about the power

modes, go to www.dyson.com/airblade

Troubleshooting

Hand dryer cuts out

After 30 seconds of continued use the hand

dryer will turn off automatically. Remove and

replace hands to restart.

Turn the machine off and on again at the

mains electricity supply.

Make sure the sensors are clean.

Check the air apertures are clean and free of

dust and blockages. If the air apertures are

dusty, simply remove dust.

Check that the air inlet is free from blockages.

Dry time has increased

Make sure that the correct power mode has

been selected.

Check that the air inlet is free from blockages.

Inspect the air apertures for dust,

and remove.

Airflow is running hotter

than usual

Check that the air inlet is free from blockages.

Inspect the air apertures for dust,

and remove.

Air is continuously running

After 30 seconds of continued use the hand

dryer will turn off automatically. Remove and

replace hands to restart.

Check that the air inlet is free from blockages.

Inspect the air apertures for dust,

and remove.

Contact Dyson for further support

and information or online at

www.dyson.com/airblade

Cleaning

The hand dryer should be cleaned daily.

Wipe the sensors using a soft cloth and non-

abrasive cleaner.

Important information

Don't pressure wash the machine.

All cleaning chemicals should be used

exactly as indicated by the manufacturer’s

instructions (including appropriate dilution).

Any chemicals intended for use should first be

tested on an inconspicuous area to confirm

suitability. Aside from cleaning chemicals,

care should be taken to avoid any harmful

fluids from coming into contact with the

machine, in particular oils and alcohol-

based products.

Filter maintenance

Regularly check the air inlet to ensure that it is

free from dust and debris. Simply wiping the

inlet with a soft cloth should be sufficient to

remove dust and debris.

If the air inlet gets clogged, further cleaning

or a filter change might be required.

If required for high usage environments, a

Dyson filter change kit provides everything

needed to change your machine’s HEPA

filter on site. Contact the Dyson Helpline for

more information.

Filter cleaning or replacement for your hand

dryer can be carried out by carefully following

the instructions given in the filter change kit. If

in any doubt, consult a qualified electrician or

contact the Dyson Helpline for support.

Servicing

If your hand dryer needs servicing, please

call the Dyson Helpline or visit the website at

www.dyson.com/airblade

07.08.2019 10:12 - C101785-HU03_OPMAN_GLOB_X280-1A-OPMAN-TEXT-101785_15_4c0s

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dyson Airblade 9kJ Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Dyson Airblade 9kJ

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info