11
D
S
GB
F
햲 A clearance between the
AIRTRONIC
and vehicle
floor is absolutely necessary – in addition,
check that the impeller is running freely
햳 Mounting surface must be level
햴 Flange seal, must be mounted
햵 The vehicle wall must be level
햶 Reinforcing plate (if necessary, see above)
햷 Spring disk
햸 Hexagon nut M6
Tightening torque 5
+1
Nm
Mounting Mounting
on the vehicle floor on the vehicle wall
horizontal
Mounting
Drill break-through holes for exhaust gas, combus-
tion air and fuel ducts according to the adjoining hole
pattern.
The supporting surface for the heater's foot must be
level. Tools can be obtained from the manufacturer
for drilling the holes and for levelling the mounting
surface.
The 10.5 mm diam. hole for the “dosing pump” cable
duct is not shown in the hole pattern and must be
Hole pattern
Mounting the AIRTRONIC
Special tools
drilled in keeping with the existing mounting
conditions. An additional reinforcing plate must be
used if the plate of the mounting surface is less than
1.5 mm thick.
Order No. – Reinforcing plate 20 1577 89 00 03
Order No. – Levelling tool 99 1201 46 53 29
