Bedienungsanleitung Eccotemp 20H (Seite 45 von 56) (Englisch)

782666

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

PLEASE NOTE: 20H IS FOR OUTDOOR PERMANENT INSTALLATIONS ONLY AND 20HI IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL

AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT WWW.ECCOTEMP.COM/SUPPORT FOR MORE INFORMATION.

Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483

English

Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator

Water Temperature Setting continued…

Set Temperature Memory:

1. This model can memorize and save the last set temperature on the remote control with “priority”.

2. If no remote control has “priority”, the set temperature of the unit will be the same as the set

temperature of the remote control which starts the water heater.

• This water heater contains an electronically

controlled thermostat. From the factory, the

temperature range is between 90°F and 140°F.

• The remote control is factory preset to 110°F.

• To turn the remote control ON or OFF, press

the POWER button for more than 3 seconds.

• To adjust the temperature to a required

setting, in“priority” mode, press the UP or

DOWN temperature button. Press and hold UP

or DOWN to raise or lower the temperature

continuously.

• When the unit is in use, the set temperature

can increase to 122°F, but there is no limit

to temperature decrease. To increase the

temperature more than 122°F, the water will

need to be shut o rst.

NOTICE: If inlet water temperature is high,

and set temperature is low, the actual

temperature might be higher than the set

temperature, and vice versa.

• The display will read the set temperature if the

water heater is not in use or there is no water ow.

If the water heater is in use or has water ow, the

display will read the actual temperature. To view

the set temperature in this condition, press UP or

DOWN and the set temperature will ash for 3

seconds.

• The hottest temperature water will be at the hot

water faucet closest to the water heater

• Always remember to test the water temperature

with your hand before use and remember that

hotter water increases the risk of scald injury.

• Always supervise young children or others who are

incapacitated.

• If the water heater has been subjected to re,

ood or physical damage, turn o the manual gas

shut-o valve(s), and do not operate the water

heater again until it has been checked by qualied

personnel.

WARNING: Should overheating occur or the gas supply fail to shut o, turn o the manual gas

control valve to the water heater.

NOTICE: If the BATH control ls turned on, the temperature setting on the MAIN control cannot be

changed. The BATH control(s) will always have PRIORITY over the MAIN control.

Water Quality

Proper maintenance of the water heater is required to ensure that your water meets EPA quality standards.

• The following table shows the maximum

contaminant levels allowed, based on the

EPA National Secondary Drinking Water

Regulations (40 CFR Part 143.3).

NOTICE: If you suspect that your water is

contaminated in any way, discontinue use of

the water heater and contact an authorized

technician or licensed professional.

Operating

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eccotemp 20H Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info