Bedienungsanleitung Eccotemp 20HI (Seite 25 von 56) (Englisch)

782667

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

PLEASE NOTE: 20H IS FOR OUTDOOR PERMANENT INSTALLATIONS ONLY AND 20HI IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL

AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT WWW.ECCOTEMP.COM/SUPPORT FOR MORE INFORMATION.

Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483

English

Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator

Installing the 20HI Water Heater continued....

WARNING: Combustible construction refers to adjacent walls and ceilings and should

not be confused with combustible or ammable products and materials. Combustible and/

or ammable products and materials should never be stored in the vicinity of this or any

gas appliance.

20HI Installation

• The water heater should be installed far from heat sources, ammable and dangerous

materials. Because of natural air movement in a room or other enclosed space, ammable

vapors can be carried some distance from where their liquids are being used or stored. The

open ame of the water heater’s main burner can ignite these vapors causing an explosion

or re which may result in severe burns, death or property damage.

• Raising the water heater will reduce, BUT NOT eliminate the possibility of lighting the

vapor of any ammable liquids which may be improperly stored or accidentally spilled.

• If the water heater is installed in a garage, it should be installed so that the direct ignition

system and main burner are no less than 18 inches above the garage oor.

• Hot and cold water lines should be insulated to conserve water and energy.

• The water heater must be located so it is not subject to physical damage, for example, by

moving vehicles, area ooding, etc.

• The water heater should be installed with the proper venting materials and termination

suitable for Category III venting. Failure to install and properly vent the water heater to the

outdoors as outlined in the Venting Section of this manual can result in unsafe operation.

• Owner must refer to vent manufacturer’s instructions and specications. Z-Flex information

can be found at www.novaex.com, please refer to page 32 for additional links.

• For other than a direct vent appliance, the appliance must be located as close as

practicable to a chimney or gas vent.

• DO NOT install water heater where subject to vibrations or on the road use.

• DO NOT install the water heater in Recreational Vehicles, Mobile Homes, Boats and other

Watercraft.

• DO NOT install the water heater near vents for heating or cooling. A minimum of 4 feet

should be maintained.

• If the clearances stated on the Instruction/Warning Label, located on the side panel of the

heater dier, install the water heater according to the clearances stated on the label.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eccotemp 20HI Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info