Bedienungsanleitung Eccotemp CEL10 (Seite 10 von 16) (Englisch)

782631

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

CE-L10 English

English CE-L10

Phone: 866-356-1992 | Email: Support@eccotemp.com Phone: 866-356-1992 | Email: Support@eccotemp.com

PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED NOR HAS IT BEEN TESTED FOR ANY PERMANENT INSTALLATIONS. THIS MODEL

IS PART OF OUR PORTABLE SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM DRY PLACE AFTER EVERY USE.

THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE.

10 11

Support: Eccotemp.com/help-desk Shop Online: eu.eccotemp.com/products Store Locator: Eccotemp.com/locatorSupport: Eccotemp.com/help-desk Shop Online: eu.eccotemp.com/products Store Locator: Eccotemp.com/locator

Warning: This model is intended for recreational & portable use only. This

model CANNOT be permanently mounted or plumbed in any way.

1. Turn on incoming water supply. Ensure that you have adequate water pressure

of between 40-5O PSI / 2.7 - 3.4 bar.

2. Turn your water output device to its “o” position.

3. Turn the gas valve on the cylinder all the way open.

4. IF THE SMELL OF GAS IS DETECTED, TURN OFF THE GAS VALVE IMMEDIATELY!!

5. Set the water regulator knob on the face of the portable tankless water heater

to its highest setting.

6. Set the gas regulator knob on the face of the portable tankless water heater to

its minimum setting.

7. Turn on your water output device to the “on” position and adjust to the desired

water ow.

8. There will be a series of audible clicks and the burner will ignite. Should the

burner not ignite after 5 seconds, shut o and go to the “Trouble Shooting”

section.

9. Upon completion of use or storage, open the drain valve (ribbed cylindrical

stem next to the water input valve) to ensure draining of water.

10. Turn o your gas supply.

11. WARNING: If the outside temperature is around or below freezing (32 degrees

F, 0 degrees C), ensure that the drain valve is opened and water drained from the

portable tankless water heater after each use to avoid internal damage to the

water regulator. You will also need to unhook the outgoing water line to ensure

that any water in the heat exchanger is drained. Failure to properly drain your

portable tankless water heater will cause water damage which may or may not be

reparable. Please check the warranty information found on our website at www.

eccotemp.com/freeze for more information on freezing issues.

Use and Starting

Before going to the USE section:

Check around area for ammables, especially gasoline or other vapors which may ignite. The Exhaust

and top of the portable tankless water heater will get HOT! Make sure there are no foreign objects

around the portable tankless water heater or have fallen into the top.

Ensure that the unit is at least 60cm o the ground and equally removed from any inammable

materials. Always use the mounting tab on the back of the unit, this will ensure the proper 1cm spacing

between the unit and a wall or post sensitive to heat. Ensure that no obstruction or projection reduces

the space between the unit and the wall or post to less than 1cm.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eccotemp CEL10 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Eccotemp CEL10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info