Bedienungsanleitung Eccotemp L10 (Seite 14 von 18) (Englisch)

782665

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED NOR HAS IT BEEN TESTED FOR ANY PERMANENT INSTALLATIONS. THIS MODEL

IS PART OF OUR PORTABLE SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM DRY PLACE AFTER EVERY USE.

THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE.

English L10

14 15

Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator

Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483 Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483

c. Out of, or low on gas. Propane gas cylinders sometimes are contaminated with air, especially new

tanks upon their rst lling. Cycle the portable tankless water heater on and o by using the shower

head switch several times (5) to purge the air from the gas. If this doesn’t clear the air then the tank

must be purged.

d. One of the ignition sensors is bent and/or too close to the burner. Look to ensure that the

ignition pins and the heat sensor are completely vertical and they do a 90 degree to the back of the

box. If they are not straight (i.e. a 45 degree angle) then you can straighten them with pliers.

e. The thermocouple is either too high or too low to complete the circuit. Check to ensure that the

thermocouple is ush with the hole in the heat exchanger.

f. The gas sensor wire (looks like a black ground wire on the gas regulator) ange might have come

loose or is no longer connected.

g. There is a faulty heat sensor. This is usually diagnosed by taking the front case o of the portable

tankless water heater and let it run. If it continues to operate, then one of the sensors and/or the

wire harness needs to be replaced. This may also be caused by insucient clearance on the back of

the portable tankless water heater where the majority of air intake is.

h. The valve on the propane tank should be all the way “Open”.

i. Freshly charged batteries are required for ignition spark. Make sure batteries are aligned in the

proper polarity (+/-).

The water does not get hot enough:

a. You are operating the portable tankless water heater above 4,000 feet / 1,000 meters. We only

recommend using it below elevations of 4,000 to 5,500 feet.

b. Look into the viewer panes (middle horizontal windows on the front cover) to see if there is a

blue ame. If the ame is yellow there could be a cracked gas regulator. Do Not Attempt to use the

portable tankless water heater and call Eccotemp directly at 866.356.1992.

Water is owing, but there is no hot water coming out:

a. Ensure that you have the incoming water supply and the outgoing water supply hooked up

properly. Your water supply should be attached to your incoming connection (located on the

far right) and the shower head should be attached to the outgoing water (located as the center

connection).

b. Ensure that you have adequate water pressure of at least 20 PSI / 1.38 bar, sustained.

c. Ensure that you have adequate gas in your propane bottle and that the LP regulator is threaded all

of the way on to the portable tankless water heater.

d. Fresh batteries are required for ignition spark. Make sure batteries are aligned in the proper

polarity (+/-).

If you are still having troubles or are on a modied water system, please visit our helpdesk located at

www.eccotemp.com for additional troubleshooting steps.

The portable tankless water heater does nothing:

a. Ensure that you have your water source hooked up to the water inlet side (far right connection)

and the shower handle is hooked up on the water outlet side (middle connection).

b. Ensure that you have an adequate supply of propane.

c. Ensure that you have freshly charged batteries.

If you are still having troubles or are on a modied water system, please call techincal support at

866.356.1992.

Troubleshooting Continued...

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eccotemp L10 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info