Bedienungsanleitung Eccotemp L5 (Seite 16 von 21) (Englisch)

782629

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

ENGLISH

C US

Support: Support.Eccotemp.com Shop Online: Eccotemp.com Store Locator: Eccotemp.com/locator

PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED, NOR HAS IT BEEN TESTED FOR ANY PERMANENT OR INDOOR INSTALLATION. THIS

MODEL IS PART OF OUR PORTABLE, OUTDOOR SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM, DRY PLACE AFTER EVERY

USE. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. VISIT SUPPORT.ECCOTEMP.COM FOR THE

LATEST VERSION OF THE MANUAL AND WARRANTY.

Troubleshooting Continued...

Portable tankless water heater will not start – but there are audible clicks at startup:

1. The portable tankless water heater requires a minimum of about .75 GPM and a minimum of about 25 PSI.

Note: water pressure is at the lower end of operating parameters. You will need a sustained water pressure of

approximately 25 – 60 PSI for adequate use if you are using a 12/18/120 volt pump. See adjustment in previous

section.

2. High Wind: for safety reasons the tankless heater will not start in sustained wind. Find an alternate location for

the tankless water heater.

3. Out of, or low on gas. Propane gas cylinders sometimes are contaminated with air. Especially new tanks upon

their rst lling. Cycle the portable tankless water heater on and o by letting water run through the L5 to purge

the air from the gas.

4. One of the ignition sensors is bent and/or too close to the burner. Look to ensure that the ignition pins and the

heat sensor are completely vertical and they do a 90 degree to the back of the box. If they are not straight (i.e. a 45

degree angle) then you can straighten them with pliers. Please visit support.eccotemp.com or call 1-866-356-1992

for assistance with this matter.

5. The gas sensor wire might have come loose or is no longer connected. Please visit support.eccotemp.com or call

1-866-356-1992 for assistance with this matter.

The water does not get hot enough:

1. Ensure you are not operating the portable tankless water heater above 2,000 feet. While it has been eld tested

up to 2,000 feet, we only recommend using it below 2,000 feet. For every 1,000 feet above the recommended

2,000 feet, you will see a 10% decrease in eciency and performance.

2. Be sure you have your gas knob turned to max and your water knob turned a little lower towards min. The less

water moving through the water heater will allow for a higher temperature.

Please note: Your incoming water temperature will play a major role in the achievable temperatures your water

heater can reach. The colder the incoming water is, the lower the achievable temperature will be. You’ll need to

adjust your hot and cold knobs to help counteract the colder incoming water. Variable factors such as incorrect or

imperfect installations and varying incoming water temperatures may yield dierent results.

3. Look into the viewer panes (3 small windows on the front cover) to see if there is a blue ame. If the ame is

yellow there could be a cracked gas regulator. DO NOT ATTEMPT to use the portable tankless water heater if a

cracked gas regulator is suspected. Visit support.eccotemp.com or call 1-866-356-1992 for assistance with this

matter.

Water is flowing, but there is no hot water coming out:

1. Ensure that you have the incoming water supply and the outgoing water supply hooked up properly. Your water

supply should be attached to your incoming connection (located on the far right) and an outgoing water line

should be attached to the outgoing water connection (located as the center connection).

2. Ensure that you have adequate water pressure of at least 25 PSI sustained.

3. Ensure that you have adequate gas in your propane bottle and that the LP regulator is threaded all of the way

onto the portable tankless water heater.

4. Fresh batteries are required for ignition spark. Make sure batteries are aligned in the proper polarity (+/-): at

negative of battery toward the spring side of battery compartment.

The portable tankless water heater will not stay on:

1. The portable tankless water heater requires a minimum of about .75 GPM and a minimum of about 20 PSI to

activate and approximately 25 sustained PSI to continue to operate. Consider your water source: Are you using a

pump to draw water from a source? Be sure the pump you are using provides adequate sustained water pressure

to activate and keep the water heater running.

2. Check that your batteries are fresh and aligned with the proper polarity (+/-): at negative of battery toward the

spring side of the battery compartment.

TROUBLESHOOTING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eccotemp L5 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info