Bedienungsanleitung Echostar dsb 707 via (Seite 7 von 66) (Englisch)

424696

Zoom out

Zoom in

Vorherige Seite

1/66

Nächste Seite

Safety Information

Section 1

Digital Satellite Receiver Page 1 - 1

SAFETY INFORM ATION

1. GENERAL SAFETY

Read this manual carefully and make sure you understand the instructions given. For your

safety, know what the reaction upon each action will be. Do not perform any actions which are

not described in this manual, failing to do so might result in an uncontrolled behavior of the

receiver or even in a hazardous situation for persons and/or equipment.

Disconnect the receiver from the mains before you start any maintenance or installation

procedures. Do not use alcohol or ammonia based liquids to clean the receiver. If required,

clean with a soft lint-free cloth slightly made damp with a mild soap solution.

Consult an authorized service technician if the receiver does not operate normally when the

instructions in this user manual are strictly followed. Do not to attempt to open the receiver, as

youwillbeexposedtoashockhazard.

Do not put any objects on top of the receiver which could fall through the ventilation slots or

which could cover them and prevent proper cooling of the components inside.

Do not put any (foreign) objects into the ventilation slots. This can cause fire or an electrical

shock by shorting the internal components.

Make sure that nothing rests on the receivers cables and that the cables are not located

where they can cause injury to persons and pets (e.g to stumble over, eat the cable).

Do not install the receiver:

■ in a closed or poorly ventilated cabinet;

■ directly on top of or under another equipment;

■ on a surface which will obstruct the ventilation slots.

Do not expose the receiver and it’s accessories:

■ to rain or excessive moisture to avoid the risk of shock or permanent damage to your

receiver;

■ to direct sunlight, heaters, stoves or any other heat generating equipment;

■ to any magnetic objects, such as speakers, electric motors, transformers, etc.;

■ to excessive vibration.

To help avoid possible damage to the receiver’s electronics:

■ wait 5 seconds after you switched off the receiver before you move the receiver or discon-

nect any equipment;

2. ELECTRICAL SAFETY

When using or connecting electrical equipment always observe the safety regulations

applicable in your country to reduce the risk of fire, electrical shock, and personal injury.

Read and comply at least with the given safety instructions.

■ Always make sure that the electrical power supply corresponds with the voltage on the

electrical identification plate at the rear of the receiver next to the electrical cord.

■ Your receiver is double insulated and complies with the EN 50144; therefore no additional

earth wire is required, though the use of an earth leak switch and/or over voltage protec-

tion switch is recommended.

■ Only use an approved extension (convenience) lead suitable for the electrical power con-

sumption of the installed equipment.

Downloaded from www.Manualslib.com manuals search engine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Echostar dsb 707 via Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Echostar dsb 707 via

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info