Bedienungsanleitung Ecm Classika PID (Seite 26 von 34) (Deutsch, Englisch)

669390

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

ENGLISH

Instruction manual CLASSIKA II / CLASSIKA PID

6.5 Preparing coffee

Use the portafilter with the corresponding filter (1 cup) for the preparation of 1 cup and use the big filter (2 cups) to

prepare two cups. Make sure that the filter is firmly locked into the portafilter.

Fill the ground coffee (with the respective grind for espresso or Café Crème) into the filter (approx. 7 g – 9 g).

Compress the ground coffee with the tamper. Clamp the portafilter firmly into the brew group.

Place the cup under the spout of the portafilter (for the preparation of 2 cups, put 1 cup under each spout).

Now activate the brew lever to start the brewing process.

If you are using a CLASSIKA PID, the timer on the PID-display indicates the brewing time in seconds. In general, the

brewing time should be around 23 to 25 seconds. The volume for a single espresso is circa 25 to 30 ml.

Place the brew lever back into the original position once the desired volume is reached.

The remaining pressure/water will be discharged into the drip tray through the lower part of the infusion cylinder.

If the group lever is not moved into the lower position properly, hot water and grounds disposal will

squirt out of the brew group while taking out the portafilter. This may cause injuries.

6.6 Dispensing of hot water

Place an adequate container (with heat-insulated handle) under the steam/ hot water dispenser. You can dispense

hot water by activating the pump/ hot water switch and opening the valve.

6.6 Dispensing of steam

The CLASSIKA II / CLASSIKA PID makes it possible to generate large amounts of steam in order to heat or froth

beverages, e.g. milk or punch.

Please follow the instructions below. Do not bring the milk to a boil, otherwise frothing milk will not be possible. For

cappuccino and white coffee preparation, first brew the coffee and then start steam dispensing.

For high-pressure steam dispensing, the water in the boiler has to be heated to more than 100 °C.

Important!

Activate the steam switch by moving it into the upper position. The indicator of the pump pressure

gauge may move slightly.

Open the steam valve for approx. 5 seconds in order to reduce the boilers water capacity and generate a larger steam

volume. Repeat this process twice in intervals of 20 seconds.

Immerse the steam nozzle at the end of the steam dispenser into the liquid. Now re-open the steam dispenser and

heat or froth the liquid.

Always keep the steam nozzle underneath the surface of the liquid in order to avoid sprayings (danger

of injury).

Switch off the steam function.

Advice

After frothing or heating the milk, release the steam into the drip tray to keep the steam nozzle holes

clean.

Clean the steam nozzle and the steam dispenser after every use with a damp cloth in order to remove

possible liquid residues.

Attention: Be careful while cleaning the steam dispenser. Avoid skin contact (danger of injury).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ecm Classika PID Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info