Bedienungsanleitung Ecm Synchronika (Seite 30 von 62) (Deutsch, Englisch, Holländisch)

654249

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

ENGLISH

Translation of the original German user manual 29

dispensing as soon as the PID display indicates the pre-set nominal temperature of 123°C (253.4 °F

factory setting) or the boiler pressure gauge indicates a value between 1.0 and 1.5 bar.

9. Manual boiler venting is not necessary because the SYNCHRONIKA contains a professional anti-vacuum

valve, which automatically vents the boiler during the heat-up phase. This venting process is done by way

of the brew group, directly into the drip tray.

Caution, steam forms!

10. Please consider that the procedure described in the steps above is the same if the steam/ hot water

boiler is deactivated: also in this case the steam/ hot water boiler will be filled and the PID display

indicates the temperature in the steam/ hot water boiler.

11. The machine is now ready for use.

5.2 Machine in use with a direct water connection (steam/ hot water boiler activated)

(steam/ hot water boiler activated)

1. Please make sure that the valve at the bottom panel of the machine and the switch behind the drip tray

are in the correct position (see images 1 and 2 chapter 4.3).

2. Make certain that the pump pressure gauge indicates enough pressure (max. 2 bars).

3. Plug the machine into an electrical outlet.

4. Turn the machine on by placing the metal switch in the upper position. The green control lamp and the

PID display will come on and a pump noise will be heard. If there is still a pump noise, the filling of the

steam/ hot water boiler is still being completed.

Fill mode (see chapter 5.1)

The PID-display indicates “FIL”. Now position the brew lever upwards for at least 30 seconds at a time to

fill the coffee boiler. The display indicates the time in seconds.

Move the lever back into the lower position. The “FIL” display turns off.

5. As soon as both boilers are filled with water, the pump will become quiet. The PID display and the orange

control lamp will illuminate. Both boilers are now being heated in succession whereby the coffee boiler

has priority.

6. Continue as described in chapter 5.1

Before preparing the first coffee, please rinse the machine by extracting about 5-8 l from

the brew group and the hot water wand. When the machine is switched off, more hot water

can be dispensed. See also chapter 6.4 Dispensing of hot water.

Only use the machine on a water-resistant surface.

High water pressure can result in damages to property and machine. Please make sure the

water pressure does not exceed 2 bar.

Portafilter, drip tray, drip grid and water tank are not suitable for the dish washer.

The SYNCHRONIKA has a fuse to prevent the machine from overfilling.

It is possible that the machine does not heat up when using it for the first time or when

dispensing large quantities of water through the hot water valve. In this case, please switch

the machine off and on again.

6. USE OF THE MACHINE

6.1 Preparation of the machine

The switched off machine is to be placed into operation as follows:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ecm Synchronika Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ecm Synchronika

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info