Bedienungsanleitung Ecoforest Vigo II (Seite 32 von 132) (Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

742210

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

If the tube that was installed previously was used with another type of heating (wood, oil, etc.), you MUST

clean it thoroughly, to reduce the risk of fire in the gas vent.

4.21. Gas outlet flex cannot be installed in a share pipe such as the pipe of an extractor hood, another stove or

heating system.

4.22. If gas outlet installation is wrong, combustion air’s homogeneity might be bad which could make the wall of

the house or the building dirty, aggregate trash inside the stove and thus be the source of premature

degradation of the spare parts and gas outlet pipe.

4.23. The air input pipe should not be drained with the risk of affecting the correct operation of the stove. For this

reason, and in order to facilitate fresh air input, it is necessary to set up a ventilation grid AT NOT LESS than

50cm both horizontally and vertically from gas output, see point 4.17.

Direct air currents shall also be avoided as they might prevent a correct operation of the stove and as a

consequence, heat performance.

Ventilation of the room must meet the minimum flow required according to specific regulations and the

maximum intake air flow of the machine.

Extraction fans can cause problems when operating in the same room or in the same space as the appliance.

4.24. In any case the design of the chimney termination will impede the free diffusion in the atmosphere of

combustion products. A metallic mesh with a gap of 3x3 cm can be placed to avoid the entry of birds or

unwanted objects.

4.25. If a testing module is installed to collect combustion gas readings and samples, it must be equipped with

hermetic and self-locking sealing.

EXAMPLES OF FLUE INSTALLATIONS.

Although we cannot keep track of or describe every single installation, option, or the local installation

regulations corresponding to your area, Ecoforest guarantees that the installations suggested below will enable

your stove to function properly, and to conform to minimum personal and material safety measures.

If you are installing your stove in a building, in addition to respect local regulations on gas flues, you should

consult with the residents’ association to avoid future problems.

Please read the entire manual carefully, especially the chapter on installation to ensure your stove

operates properly and at full power.

If the total pipe length exceeds 8m, it is recommended to increase one measure, being able to make the

whole assembly in the same diameter from the connection of the stove or increase section from 4 m.

4.26. The installation shown below is the one recommended by Ecoforest to get the best machine performance.

The pipe section will run at least 2 meters vertically through the interior of the house.

Drawing 9

Other installations are possible as well (please check with your authorised dealer.) Other possibilities are

added herebelow:



Windbreak



Stainless steel hose clamp.



T of 90° with outlet



Insulator



Wooden ground



Non flammable

floor protection



Elbow of

90°.



*Distance equal to or over 2 metres.

1(

MAXIMUM

1 metre.



 











Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ecoforest Vigo II Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info