Bedienungsanleitung Ecoforest Vigo II (Seite 41 von 132) (Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

742210

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

5.16. Review the glass door joints.

Review in detail any imperfections which may cause an air inlet. Replace them if necessary.

5.17. Cleaning the dirt which may be accumulated inside the stove, accessing through the back.

5.18. Empty the hopper to take remaining pellets out to avoid pellets absorb humidity.

IMPORTANT: After cleaning or fixing, make sure the stove operates correctly. Once you turn the stove off or

during the seasons when you do not use it, disconnect the stove to avoid electronic damages.

CHECKING AT BEGINNING OF SEASON.

It consists in controlling the combustion air inlet and gas outlet; make sure nothing prevents normal

circulation (e.g. bird nests). The gas outlet must also be inspected for possible water infiltrations.

In addition, it is recommended to clean the base of floor of the stove, the back side of the stove that you

reach through the back grid or lateral doors, in order to take eventual dust away that might have stacked during

summer time.

6. PROBLEMS AND RECOMMENDATIONS.

WHAT NOT TO DO.

6.1. Do not turn the stove on and off successively because this might damage the electronical components and

motors ~230/240V - 50Hz.

6.2. Do not touch the stove while your hands are wet. Though the stove is equipped with ground plug, it remains

an electric machine that could cause electric discharge if handled incorrectly. A qualified technician only shall

resolve the eventual problems.

6.3. Do not remove any screw of the zones exposed to high temperature before they have been lubricated

properly with lubrication oil.

WHAT DO TO IF...

THE STOVE REMAINS OUT OF POWER:

6.4. Make sure the stove is connected and the plug is leading power.

6.5. Make sure the cable is not damage or cut.

While the stove is disconnected, dismantle the right side of the stove and check if any lead of the C.P.U. is

slack.

6.6. Check the C.P.U pilot. If it is OFF, check also the fuse on the C.P.U.

PELLETS DO NOT FALL AND THE STOVE DOES NOT TURN ON:

6.7. Check if there are pellets in the hopper.

6.8. Make sure the glass door is closed.

6.9. Make sure the gas outlet tube is not obstructed by anything (e.g. bird nest, plastic, etc.).

6.10. Make sure the exhaust motor works, because if it does not work fuel will not fall.

6.11. If the reducer motor does not rotate and the displays indicates the pulses, the first thing to do will be unplug

the stove and verify if the safety thermostat has been activated. With the stove unplugged, check that the

safety thermostat is located inside the stove, by opening the right side. To activate it, you must press the

button. If the thermostat is activated you will hear a “click”. If the safety thermostat had been activated

before, consult your dealer.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ecoforest Vigo II Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info