668110
19
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
9.Remote Control
Note
Tips:
Tips:
When power is off, robot will not start work on appointment time .If you have already set appointment time
cleaning, please turn on the robot and keep it on standby status even though it is not operating. Try to
make it stay at the charger and check whether it is connected.
Make sure the socket is connected to power supply. Or else, robot will fail to work on appointment time under
standby status because of running out of . battery
Set Frequency and Cancel Timing
No matter what kind of mode the robot operated in the last time, when the appointment time
coming, robot will work according to the Automatic mode.
If the robot is operating in Border cleaning mode, Fixed point cleaning mode, when the
appointment time coming, robot will not work until the next appointment time.
You can set appointment cleaning frequency via press then release.
to clean on appointment time for one time.
to clean on appointment time everyday hereafter.
to cancel appointment timing, robot only works upon your manual
operation.
work for
one time
work
everyday
do not
work
Battery Placement
It applies two units of alkaline batteries (7#).
Please note the positive and negative when place the battery.
Change the battery when you notice it is in low battery and make sure you use the same kind of battery as
mixture is forbidden.
Take out the battery if you do not use remote control for long time to avoid electrolyte from leaking which
may cause failure.
Do not put the remote control in extremely hot or humid surroundings.
Do not fill any other substance into remote control, especially when you change battery.
Never expose the signal transmitter under sunshine or lighting equipment, or else it would cause failure.
The deposal of used battery should conform with local environmental legislation.
Press the key , the robot
will work as belowing sequence:
17
Enj o y Sma r ter L i fe!
Downloaded From Vacuum-Manual.com Manuals
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

ecovacs-deebot-d58

Suche zurücksetzen

  • Linker Antrieb geht zeitweise nicht mehr, dreht sich nur im Kreis? Eingereicht am 14-10-2019 11:37

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ecovacs Deebot D58 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info