Bedienungsanleitung Edilkamin ATLANTA UP (Seite 10 von 36) (Englisch)

810884

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

ENGLISH

EXTERNAL AIR INTAKE

Install an intake at floor level with effective area (net of

the mesh or other protective equipment) of at least 80

cm2 (10 cm dia.).

To prevent draughts, we recommend installing the

intake behind the stove or behind a radiator.

The boiler is not designed to be connected directly to

the air inlet

INSTALLATION

CHECKING THE ELECTRICAL CONNECTIONS

(the power socket must be located in an

easy to access position)

The stove is equipped with an electrical power cord

or connection to a 230V 50 Hz socket, preferably with

electromagnetic cutout.

Variations in voltage of more than 10% can compromise

the operation of the stove.

The electrical system must be compliant; check the

operation of the earth in particular.

Edilkamin is not responsible for malfunctions resulting

from an improperly earthed system.

The power line must be of adequate section for the

power of the appliance.

The power cord must not come into contact with the

hot parts of the stove, including the flue.

Power up the product by setting its switch from 0 to 1.

There are two fuses in the socket with the switch on

the back of the boiler: one operational and the other

a spare.

Fig.3

THE FLUE:

Further to the general prescriptions for the fumes duct

and flue, the flue:

• must serve solely to exhaust fumes

• must be correctly sized to satisfy the requirements

of fumes exhaust (EN 13384-1)

• should preferably be insulated, in steel with a

circular internal section. If rectangular, the corners

must have a radius of not less than 20 mm, with a

ratio of the internal dimensions of <1.5

• must normally be at least 1.5 metres in vertical

length

• must have a constant cross section

• must be waterproof and thermally insulated to

ensure a good draw

• must preferable have a collection chamber for

• If pre-existing, must be clean, to prevent the fire

hazard.

• in general, we recommend fitting a tube inside the

existing masonry chimney if its diameter is greater

than 150 mm.

INTUBATED SYSTEM:

Further to the general prescriptions for the fumes duct

and flue, the intubated system:

• must operate in negative pressure;

• must be open to inspection

• must observe local regulations.

THE CHIMNEY POT

• must be windproof

• must have an internal cross section equivalent to

that of the flue and a fumes outlet at least double

that of the interior of the flue

• for dual flues (which should be spaced at least 2

m apart) the chimney pot receiving the fumes from

the solid fuel appliance or that from the higher

storey, must be at least 50 cm higher than the other

• it must extend beyond the back flow zone (in Italy,

refer to UNI 10683 point 6.5.8.)

• it must allow for maintenance of the chimney

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin ATLANTA UP Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin ATLANTA UP

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info