Bedienungsanleitung Edilkamin Blade H (Seite 17 von 52) (Englisch)

810900

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

ENGLISH

THE FLUE:

Further to the general prescriptions, the flue must

• only be used to discharge smoke

• be correctly sized to satisfy the requirements of

smoke discharge (EN 13384-1)

• must preferably be insulated, in steel with a circular

internal section. If rectangular, the corners must

have a radius of not less than 20 mm, with a ratio

of the internal dimensions of <1.5

• must normally be at least 1.5 metres in vertical

length

• must have a constant cross section

• must be waterproof and thermally insulated to

ensure a good draw

• must preferable have a collection chamber for

non-combusted matter and condensation.

• if pre-existing, it must be cleaned to prevent any

fire hazard

• in general, we recommend fitting a tube inside the

existing masonry chimney if its diameter is greater

than 150 mm. This recommendation is purely for

guidance; the installer must assess wile installing,

after the calculation of the draw.

INTUBATED SYSTEM:

Further to the general prescriptions, the intubated

system must:

• operate in negative pressure

• be open to inspection

• be compliant with local regulations.

THE CHIMNEY POT must:

• be wind-proof

• have an internal cross section equivalent to that of

the flue and a smoke outlet at least double that of

the interior of the flue

• extend beyond the back flow zone (in Italy, refer to

UNI 10683 point 6.5.8.)

• allow for maintenance of the chimney

For dual flues (which should be spaced at least 2 m

apart), the chimney pot receiving the smoke from the

solid fuel appliance or that from the higher storey, must

be at least 50 cm higher than the other

AIR INTAKE FOR COMBUSTION

In general, we suggest two ways to ensure a proper

flow of combustion air. Air must come from the outside*

It is also important to ensure a change of heating air

and glass cleaning air etc.

Indirect air intake

The boiler stove takes air from the outside through the

hole on the rear.

Install an air outlet at floor level with an effective sur-

face area (net of the mesh or other protections) of at

least 80 cm2 (10 cm in diameter).

To prevent draughts, we recommend installing the

intake behind the product or behind a radiator.

Installing it in front of the appliance will create

unpleasant draughts.

Direct air intake**

Install an air intake of effective area (net of the mesh or

other protective equipment) at least equal to that of the

air intake at the back of the product.

Connect the air intake to the appliance's air intake with

a tube (which may also be of the hose type). Increase

the diameter of the pipe if it is not smooth: assess its

pressure drops.

We recommend not exceeding a length of 3 m,

considering the draw of the flue. For each curve, up

to a maximum of two, the length must be reduced by

1 m. You should also consider increasing the diameter

of the pipe.

*The air may be drawn from an adjacent room only if:

• the flow is taken from permanent and unobstructed

openings communicating with the outdoors

• the air pressure in the adjacent room is never

lower than that of the outdoor pressure

• the adjacent room is not a garage. subject to fire

hazard, a bathroom or bedroom

• the adjacent room is not a shared room in the

condominium

In Italy, UNI 10683 provides that ventilation is sufficient

even if a pressure difference between the outdoors

and indoors of no more than 4 PA is guaranteed (UNI

EN 13384-1). The installer who issues the declaration

of conformity is responsible for ensuring these

conditions.

**The direct connection of the air intake does not

make the product airtight. It is therefore necessary also

to ensure recovery of the air taken in the room by the

product (i.e. for the glass cleaning)

INSTALLATION

INSTALLER

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Blade H Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin Blade H

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info