Bedienungsanleitung Edilkamin Cubira (Seite 10 von 20) (Englisch)

810906

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

ENGLISH

THE SMOKE CHANNEL

•ifinmetalmusthaveaCEmarking(EN1856-2)or

similar national law;

•cannotbeinflexiblemetalmaterial

•

to check the flow, a shutter is advised for draft over

25 Pa

THE CHIMNEY FLUE:

• must have a draft capable of creating negative

pressure ideally around 12 Pa. Lower drafts can

cause leaking smoke if the door is open; higher

values tend to generate fast combustion by redu-

cing the yield

• must be correctly sized to meet smoke evacuation

(EN 13384-1)

• must preferably be insulated, in steel with a circular

inner section. If rectangular, the inner edges must

have a radius under 20 mm and a ratio between

between the inner dimensions <1.5

• normally have a minimum height of 3-4 metres

• maintain a constant section

• be waterproof and thermally insulated to guaran-

tee draft.

• preferably create a collection chamber for unbur-

ned fuel and any condensate

• be at least category T400, with an adequate resi-

stance to soot fireIf pre-existing, it must be clea-

ned to avoid risk of fire.

THE CHIMNEY STACK

• must be wind-proof

• have an internal section equivalent to that of the

chimney flue and passage section outlet equal to

at least double the inner passage of the chimney

flue

• for paired chimney flues (which should be at least

2 m apart) the chimney stack of the chimney flue

receiving the product discharge with solid fuel or

that of the highest floor must be at least 50 cm

taller

• must go beyond the reflux zone

• must enable chimney maintenance

INSTALLATION

CHIMNEY SYSTEM

(Smoke channel, chimney ue and chim-

ney stack)

This chapter is drafted according to the European

Standards EN 13384, EN 1443, EN 1856, EN 1457.

The installation technicians must take into considera-

tion these and any other local standards. The manual

should in no way be considered a replacement for the

laws in force.

The stove must be connected to a suitable smoke di-

scharge that guarantees completely safe evacuation

of the smoke produced by combustion.

Before positioning the stove, you need to check the

chimney flue is suitable.

The fumes outlet is at the top.

SMOKE CHANNEL, CHIMNEY FLUE

The smoke channel (pipe that connects the smoke

outlet of the fireplace with the chimney flue inlet) and

the chimney flue must, along with other legal provi-

sions:

• receive the discharge for a single product (multiple

product discharges are not permitted together)

• have a mainly vertical development

• no section should have a reserve slope

• have an inner section preferably circular and

however with a ratio between sides lower than 1.5

• complete the roof with the appropriate chimney

stack: direct discharge is forbidden on walls or

towards closed spaces, even if outdoors

• be created with materials with a fire reaction class

A1 pursuant to UNI EN 13501 or similar national

standard

• be appropriately certified, with an appropriate

fireplace plate, if metal

• keep the initial section.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Cubira Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin Cubira

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info