Bedienungsanleitung Edilkamin Double (Seite 14 von 62) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

810848

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

ENGLISH

fig. 4hatchhandledoor handle

THE TECHNOLOGY

Removable handles for opening hatch and door

The hatch handle is not fixed to the same hatch but is inserted when required.

The handle is to be inserted in the lower part of the frame, forking it in the appropriate

pegs (fig 1-4).

The handle is only needed to lift or lower the hatch.

The handle to unblock the opening of the door is also removable (fig 1 and 4).

Fuelling air

DOUBLE can only be mounted in rooms with sufficient fuelling air power supply, and must

function closed.

To have the chimney function correctly, it is essential that the fuelling air reaches the

hearth through a fine pipe on the appropriate inlets, provided at the sides and rear of the

chimney.

A fitting with a 125 mm valve to be applied to the inlet to be used ( fig. 5) is supplied.The

connection with the outside must have a useful passage section of at least 125 cm2 along

its path.

In case of use with hearth open, or if the building in which the chimney is installed is

particularly sealed, a supplementary air inlet of a further 120 cm2 useful passages, must be

provided.

Fitting with butterﬂ y valve

The fuelling air must flow to the hearth regulated by a butterfly valve

The butterfly valve is delivered as an accessory together with a flexible pipe and the fixing

bands. Unless the butterfly valve is mounted in a fixed and solid manner, the chimney

cannot be started.

The mouths not used for connecting the flexible pipe for the fuelling air passage, must

remain closed with a lid.

Mount the fuelling air regulating control in the most adequate position under the threshold.

Regulating the butterﬂ y valve

Air for the heating

the room air enters from the side inlets ( n 13 - fig. 2) obtained at the side of the shell, heats up, in contact with the metal hood and exits

from the 2 14cm holes on the lid of the same shell.

Appropriate passages on the covering must be provided so that the room air can reach the above said side inlets.

An aluminium flexible pipe to duct air in near by rooms can be applied, using appropriate fitting, to both 14 diameter holes present on the

shell lid.

fig. 5

fig. 6

fig. 7

The Edilkamin hearths, as well as heating through radiation, produce hot air which can be duct through flexible pipes, in this way heating

the whole house uniformly.

chimney room

+ 1 near by rooms

chimney room

+ 2 near by rooms

two bis kit three bis kit

„Starting“ position / max. heating power:

totally extracted air valve regulating control. Starting with cold chimney and max. hearth power. (fig. 6)

„Maintain ﬁ re“ position:

control for regulating the valve completely inserted.All air inlets are closed (fig. 7).

N.B. in case of conveyance of the hot air to rooms different from

the one where the chimney is installed, it is necessary to guarantee

the return of the same air to the chimney room, through a grill at

the base of the walls or through slots under the doors.

AIR DUCTING KITS

To facilitate the realisation of the hot air distribution system,

Edilkamin has provided two kits containing all that necessary for

the two cases, illustrated at the side.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Double Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info