810712
6
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
The appliance can be identified by means of:
- the packaging label
showing the name of the product, the code, the serial
number and the type of gas that can be used.
- The Technical Plate
showing the serial number, the model and the main
technical-performance data.
- The gas type plate
Showing the name of the gas for which the appliance
has been set and regulated. If the type of gas is
changed, this plate must be replaced with that of the
new gas!
Spare parts and/or technical jobs require the
exact identification of the associated model
of appliance.
Tampering with, removing or the absence of the
Technical Plate, etc. does not allow the exact
identification of the product, making any installa-
tion and maintenance job difficult.
This device is for decorative purposes.
Independent gas appliances for heating environ-
ments. They feature an atmospheric burner with
combustion chamber TYPE B with open flame.
The combustion air is drawn directly from the room
where the appliance is installed.
- Installation INSIDE
The discharge of combustion products may take
place in the chimney canalizzandoli with direct con-
nection to the asterno, size MIN Ø18cm.
The natural convective movement permits quick hea-
ting of the environments from when the appliance is
switched on.
- Installation OUTSIDE
If the unit is installed outdoors is not required to
achieve a chimney for exhaust fan (see chap.
Location of the unit).
An electronic board controls all the main functions of
the appliance and automatically interrupts the gas
supply in case of a fault.
The remote control features: appliance On/Off sup-
ply, heat output setting and operating condition reset
after a fault.
The device was built with materials and
components to withstand humidity and low
temperatures, nevertheless not be considered
fully water resistant.
The appliances are factory set, to operate
with Natural Gas, but are also available for
LPG (G30/G31).
This type of appliance can be transformed from
Natural Gas to LPG and vice versa with replacing
the burner.
The gas type and pressure used for operation are
shown on the technical data plate affixed to the
appliance.
Do not change the factory settings of the gas
control unit or receiver before installation.
The burner and pilot light are factory set by the
Manufacturer.
The appliance must be connected to the gas type
shown on the burner. Never ever connect a
Natural Gas burner to the LPG supply or vice
versa.
6GENERAL
DESCRIPTION OF THE APPLIANCE
IDENTIFICATION
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Edilkamin EKB80 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Edilkamin EKB80

Edilkamin EKB80 Bedienungsanleitung - Deutsch - 28 seiten

Edilkamin EKB80 Bedienungsanleitung - Französisch - 28 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info