Bedienungsanleitung Edilkamin Evia 2 (Seite 13 von 36) (Englisch)

810766

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

ENGLISH

THE FLUE:

Further to the general prescriptions for the fumes duct

and flue, the flue:

• must only be used for discharging fumes

• must be correctly sized to satisfy the requirements

for fume discharging (EN 13384-1)

• should preferably be insulated, in steel with a

circular internal section. If rectangular, the corners

must have a radius of not less than 20 mm, with a

ratio of the internal dimensions of <1.5

• must normally be at least 1.5 metres in vertical

length

• must have a constant cross section

• must be waterproof and thermally insulated to

ensure a good draw

• must preferably have a collection chamber for

non-combusted matter and condensation.

• if pre-existing, must be clean, to prevent the fire

hazard.

• in general, we recommend fitting a tube inside the

existing masonry chimney if its diameter is greater

than 150 mm.

INTUBATED SYSTEM:

Further to the general prescriptions for the fumes duct

and flue, the intubated system:

• must operate in negative pressure;

• must be open to inspection

• must observe local regulations.

THE CHIMNEY POT

• must be anti-downdraught

• must have an internal cross section equivalent to

that of the flue and a fumes outlet at least double

that of the interior of the flue

• for dual flues (which should be spaced at least 2

m apart) the chimney pot receiving the fumes from

the solid fuel appliance or that from the higher

storey, must be at least 50 cm higher than the other

• it must extend beyond the back flow zone (in Italy,

refer to UNI 10683 point 6.5.8.)

• it must allow for maintenance of the chimney.

EXTERNAL AIR INTAKE

In general, we suggest two ways to ensure a proper

flow of combustion air.

Indirect air intake

Install an air outlet at floor level with an effective surface

area (net of the screen or other protections) of at least

80 cm2 (10 cm in diameter).

To prevent draughts, we recommend installing the

intake behind the stove or behind a radiator.

Installing it in front of the appliance will create

unpleasant draughts.

Direct air intake

Install an air intake with an effective size ((net of the

mesh or other protective equipment) that is at least

equal to that of the air intake at the back of the product.

Choose the diameter based on the load losses.

Connect the air intake to the appliance's air intake with

a pipe that may also be flexible. Increase the diameter

of the pipe if the pipe is not smooth: assess any load

loss.

A maximum length of 5 metres is recommended, with

no more than 3 bends depending on the draft of the

flue.

The air maybe drawn from an adjacent room only if:

• the flow is taken from permanent and unobstructed

openings communicating with the outdoors;

• the air pressure in the adjacent room is never

lower than that of the outdoor pressure;

• the adjacent room is not a garage, subject to fire

hazard, a bathroom or a bedroom;

• the adjacent room is not a shared room in the

condominium.

In Italy, UNI 10683 provides that ventilation is sufficient

even if a pressure difference between the outdoors

and indoors of no more than 4 PA is guaranteed (UNI

EN 13384-1). The installer who issues the declaration

of conformity is responsible for ensuring these

conditions.

INSTALLATION

INSTALLER

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Evia 2 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin Evia 2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info