Bedienungsanleitung Edilkamin Mya Air Tight C (Seite 9 von 40) (Englisch)

810833

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

ENGLISH

REMARKS ON INSTALLATION

Note that:

• installation must be carried out by authorised

technical personnel;

the appliance must be installed and operated in

compliance with local and national law and European

regulations. The Italian reference standard is UNI

10683; in France one must follow the instructions in the

DTA (Document Technique d’Application), www.cstb.fr

• if installed in a condominium, the appliance must

be approved by the administrator;

• if installed in public premises, check and follow

local regulations for this type of installation.

Here are a few general instructions, although these do

not obviate the need to comply with local regulations

and do not affect the installer's liability for the

installation.

Remember that Mya Air Tight is sealed, in other

words, if it is installed correctly with the air inlet pipe

connected to the outside, it takes the majority of the

air from the outside. For different countries, check if

there are particular installation conditions allowed for

sealed stoves.

Checking the suitability of the installation

space

• The room must have a volume of at least 30 m3

• The floor must be able to bear the weight of the

product and its accessories* (see the note in the

paragraph on the heat protection)

• Level the appliance

• Pursuant to Standard 10683 rev. 2012 point 6.3, in

Italy you can also install the appliance in bedrooms

or in rooms which already include a product that

takes air from it for combustion, provided that the

air inlet is connected to the outside

• Do not install the product in spaces where there is

a risk of fire or explosion

• In Italy, check the compatibility pursuant to UNI

10683 and UNI 7129 in the presence of gas fired

products.

INSTALLATION

Protection from heat and safety clearances

The surfaces of the building adjacent to the product

must be protected against overheating.

The insulation to be used will depend on the type of

surface in question.

The appliance must be installed in accordance with

the following safety instructions:

- minimum clearance at the sides 15 cm and back of

10 cm from flammable materials

- no flammable materials may be kept closer to the

front of the appliance than 80 cm.

If connected to a wooden or otherwise flammable wall,

the flue must be appropriately insulated.

If installed on a flammable or combustible floor, or

which is not capable of bearing its load*, use steel or

glass plates under the stove to distribute the load.

Contact the retailer for this type of optional.

Positioning the product

The product is designed to operate in all climate

conditions. In special circumstances, such as strong

wind, the safety devices may intervene to switch the

appliance off.

Contact the authorised Edilkamin Technical Assistance

Centre.

INSTALLER

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Mya Air Tight C Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin Mya Air Tight C

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info