Bedienungsanleitung Edilkamin QUEBEC (Seite 35 von 158) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

810875

Zoom out

Zoom in

Vorherige Seite

1/158

Nächste Seite

ENGLISH

Refer to local regulations in the country of use for anything that is not specifically covered in this manual. In Italy, refer to standards

UNI 10683 and UNI 10412-2, as well as the Ministerial Decree No. 37, ex Law No. 46/90, in addition to any Regional or Local

Health Authority regulations. If installing in a block of apartments, first consult the block administrator.

Verify compatibility with other devices

According to standard UNI 10683/2005, the thermo-stoves must NOT be installed in the same room as extractors, type A and B gas

appliances and, in any case, devices that diminish the ventilation inside the room.

Check electrical connections (POSITION THE SOCKET IN AN ACCESSIBLE PLACE)

The stove is equipped with a electrical power cable to be connected to a 230V 50 Hz socket, preferably with a magnetothermic switch.

Voltage variations exceeding 10% can damage the thermo-stoves (unless already installed, an appropriate differential switch must be

fitted). The electrical system must comply with law; particularly verify the efficiency of the earthing system. The power line must have

suitable cross-section for the thermo-stoves’s power.

Lack of efficiency of the "ground" circuit causes malfunction for which Edilkamin cannot be held responsible.

Positioning

The thermo-stoves must be level for it to function correctly. Verify the bearing capacity of the floor.

Fire prevention safety distances

The thermo-stoves must be installed in compliance with the following safety conditions:

- medium flammability items must be kept at a minimum distance of 20 cm from the sides and

back of the thermo-stoves

- highly flammable items must be kept at a minimum distance of 80 cm if placed in front of the

thermo-stoves

- if the thermo-stoves is installed on flammable flooring, a sheet of heat insulating material must

be placed on the floor. This must extend at least 20 cm from the sides and 40 cm from the front.

Flammable objects must not be placed above the thermo-stoves or at a distance that is any less

than the stipulated safety distances. If connected to wooden walls or other flammable materials,

the smoke exhaust pipe must be appropriately insulated with ceramic fibre or other similar

material.

Air inlet: to be mandatorily implemented.

The room where the thermo-stoves is placed must have an air inlet with a cross-section of at least 80 cm² so as to guarantee sufficient

air supply to the stove for combustion.

Smoke outlet

The discharge system must only be used for the thermo-stoves (the smoke cannot be discharged into a chimney flue used by other

devices).

The smoke is discharged through the 10 cm diameter outlet at the back of the thermo-stoves. A T-junction must be set up with a con-

densation collection stopper at the beginning of the vertical section. The thermo-stoves smoke discharge must be connected with

outside by means of steel or black pipes EN 1856 certified.

The pipe line must be hermetically sealed. The pipes must be sealed and insulated using materials that are resistant to high tempera-

tures (high temperature silicone or mastic). The only horizontal section allowed may be up to 2 m long. The horizontal section must

have a minimum inclination of 3% and a maximum of two 90° bends. If the outlet is not fitted into a chimney flue, a vertical section

of at least 1.5 m will be required, complete with a wind guard. The vertical duct can be internal or external. If the smoke channel is

outside, it must be insulated.

If the smoke channel is fitted inside a chimney flue, the latter must be suitable for solid fuel. If it is wider than 150 mm in diameter,

a pipe must be entered and the outlet sealed to the masonry. All sections of the smoke duct must be accessible for inspection.

INSTALLATION

Distance from flammable material

Floor protection

A: insulated steel chimney flu, Insulated

B: minimum height 1.5 m, and however beyond the eaves of the roof

C-E: air intake from outside (through section at least 80 cm²)

D: steel chimney flue inside existing masonry chimney flue

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin QUEBEC Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info