ENGLISH
ENGLISH
SCREW FEEDER LOADING.
If the pellet hopper empties completely, press the “hourglass” key for a few seconds.
This must be done before igniting the stove again if it has shut down due to running out of pellets.
It is normal for a few pellets to be left in the hopper, which the screw feeder is not able to pick up.
IGNITION
Automatic ignition
Hold the ON/OFF key down for two seconds with the stove on standby to start the ignition procedure. The word START appears
on the display for a few minutes (the ignition procedure does not actually take a preset time: it is automatically shortened if the
electronics detect that certain tests are passed). The ame appears after about ve minutes. It is normal for a little smoke to be
seen in the combustion chamber before the ame appears. “Ar” appears on the display until the ame stabilizes.
Manual ignition
At temperatures of less than 3°C (too low for the heating element to glow) or if the heating element is temporarily out
of order, a relighter may be used for ignition. put a piece of well lit relighter in the combustion chamber, close the
door and press ON/OFF.
Operating modes (when the stove is working, press the A/m key to switch between modes)
Manual: adjust the working power (from P1 to P3 with the left knob) and the ventilation (with the right knob)
Automatic: set the temperature which the room is to reach; the stove automatically adjusts the working power to reach it
(P3) or maintain it (P1).
If you set a lower temperature than current room temperature, the stove operates at P1 and consumes the corresponding
quantity of pellets.
Note on ame variability
Any variations in the state of the ame depend on the type of pellet used, the normal variability associated with solid
fuels and the periodic automatic combustion chamber cleaning (which does NOT replace the essential cold vacuum
cleaning by the user before ignition).
Switching off
Hold the ON/OFF key down for two seconds while the stove is operating. The shutdown procedure starts and the word
“Off” appears on the display (for a total of 10 minutes).
During shutdown:
• Pellet loading ceases.
• Ventilation turns up to maximum.
• The smoke expulsion motor turns up to maximum.
Never unplug the stove while it is shutting down
