Bedienungsanleitung Edilkamin Tally Up S Evo (Seite 32 von 40) (Englisch)

810840

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

ENGLISH

INTRODUCTION ON INSTALLATION

Remember that:

•the stove must be installed by qualified staff who

can issue a Declaration of Conformity

•all the local and national laws and the European

Standards must be met for installation and use of

the product.

•In the event of installation in apartment blocks, ask

the administrator’s opinion beforehand.

The general instructions are provided below, taking

the Italian standard UNI 10683 as an example and

guideline.

Checking the suitability of the installation

premises

• The volume of the room must be over 15 m3

•Installation is not permitted in bedrooms,

bathrooms or premises with other products that

take in air for combustion of the same premises

or in premises with an explosive atmosphere. Any

extractor fans, if working in the same environment

or space in which the product is installed, can

cause draft problems.

•In Italy, check compatibility pursuant to UNI 10683

and UNI 7129 in the presence of gas products.

•The floor must be able to support the weight of the

stove and the accessories.

Protection from heat and safe distances

All the surfaces of the building adjacent to the stove

must be protected against heating.The insulation

measurements to implement depend on the type of

surface present.

Distance from flammable materials must be:

- 25 cm from the sides ;

- 20 cm from the back

In the event of installation on a floor with inflammable

material and/or combustible material or with insufficient

capacity, you are advised to position the stove on a

steel or glass plate to distribute the load.Ask the retailer

about the optionals.

INSTALLATION

CHIMNEY SYSTEM

(Smoke channel, chimney flue and chimney

stack)

This chapter is drafted according to the European

Standards EN 13384, EN 1443, EN 1856, EN 1457. The

installation technicians must take into consideration

these and any other local standards. The manual

should in no way be considered a replacement for the

laws in force.

The stove must be connected to a suitable smoke

discharge that guarantees completely safe evacuation

of the smoke produced by combustion.

Before positioning the stove, you need to check the

chimney flue is suitable.

SMOKE CHANNEL, CHIMNEY FLUE

The smoke channel (pipe that connects the smoke

outlet of the fireplace with the chimney flue inlet) and the

chimney flue must, along with other legal provisions:

•receive the discharge for a single product (multiple

product discharges are not permitted together)

• have a mainly vertical development

• no section should have a reserve slope

•have an inner section preferably circular and

however with a ratio between sides lower than 1.5

•complete the roof with the appropriate chimney

stack: direct discharge is forbidden on walls or

towards closed spaces, even if outdoors

•be created with materials with a fire reaction class

A1 pursuant to UNI EN 13501 or similar national

standard

•be appropriately certified, with an appropriate

fireplace plate, if metal

•keep the initial section or change it only immediately

above the stove output and not along the chimney

stack

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Tally Up S Evo Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin Tally Up S Evo

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info