Bedienungsanleitung Edilkamin WIDRO 85 (Seite 34 von 40) (Englisch)

34

ENGLISH

USER INSTRUCTIONS

Always use the glove provided to touch

any hot parts. Avoid direct contact with

hot parts.

Adding wood when the combustion

chamber is hot

When is the right time to add wood? When the fuel has

almost finished and is in hot embers. Using the glove

provided, open the door slowly (to avoid the creation

of air vortices which could cause smoke to leak out).

Add the desired quantity of wood into the combustion

chamber, placing it on top of the existing embers (within

the quantity limits indicated in the technical sheet).

Operation with low initial draught

In order to draw in the air for combustion and to

discharge the smoke, the combustion chamber needs

the draught created by the flue.

If the draught is weak, initially light a “start-up” fire

using smaller pieces of ignition material.

Once the correct level of draught has been restored,

you can add the fuel.

First ignition procedure

• Make sure you have read and understood this

manual

• Remove all flammable materials from the appliance

(manuals, labels, etc.). Be sure to remove the

labels on the glass. They would irreparably

damage the glass if they melted.

To light the fire in the combustion chamber, always use

smaller pieces of wood. Use larger pieces of wood to

feed the fire once it has started.

Place the wood on the combustion grille.

NOTE

On first ignition, there may be a slight smell of paint,

which will disappear over a short period, after using

the product a few times at rated capacity.

Ignition with the combustion chamber

cold.

1. Check that the existing ash bed is not too high. If the

ash bed becomes too high there is a danger that hot

embers may fall out of the combustion chamber when

the combustion chamber door is opened to add wood.

2. Move the lever for regulating the air valve to the

“fully open” position. There will be an intense flow of

combustion air to the wood in the combustion chamber

allowing quick and efficient combustion.

3. Place the wood in the combustion chamber without

packing it excessively. Place an ignition unit among the

logs, and ignite. Never use ignition products such as

petrol, alcohol and the like.

4. At this point, close the door and monitor for a few

minutes. If the fire should go out, open the door slowly,

place another ignition unit among the logs and ignite

it again.

ONLY LIGHT THE PRODUCT WITH

THE REFRACTORY ELEMENTS IN

PLACE.

PRACTICAL TIPS

It is recommended to keep radiators off in the room

where the thermo-fireplace is installed as the heat

radiated from the opening is sufficient.

•

Incomplete combustion leads to excessive build

up on the exchanger tubes. To avoid this, it is

necessary to:

•

burn dry wood

•

ensure that the combustion chamber contains a

good bed of hot embers and coals before adding

more wood

•

add logs with a larger diameter along with smaller

ones.

USER

Edilkamin WIDRO 85 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin WIDRO 85

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info