Bedienungsanleitung Edy EDHK7001 (Seite 35 von 36) (Deutsch, Englisch, Holländisch, Französisch)

726204

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Frequently asked questions

The following simple issues can be handled by the user. Please call the after-sale service

department if the issues are not settled.

Inoperation

Odor

Long-term operation

of compressor

Illuminating light

does not shine

The freezer door can

not be properly closed.

Loud noises

Whether the freezer is plugged and connected to power;

Low voltage;

Whether temperature control knob is in the work area

Failure power or tripping circuit

Odorous foods should closely wrapped;

Whether foods are rotten;

Whether the interior shall be cleaned.

It is normal that freezer operates for longer time in

summer when the ambient temperature is higher;

Do not put too much food in the freezer at one time;

Do not put foods until they are cooled;

Frequent opening of freezer door.

Thick frost layer (defrost is needed)

Whether the freezer is connected to power, whether the

indicator light is damaged.

The freezer door is stuck by food packages;

Too much food;

Tilt freezer.

Whether the food is leveled, whether the freezer is balanced;

Whether the freezer parts are properly placed.

Warm tips:

◆The freezer enclosure may emit heat during operation specially in summer, this is caused by the

radiation of the condenser, and it is a normal phenomenon.

◆Condensation: condensation phenomenon will be detected on the exterior surface and door

seals of the freezer when the ambient humidity is large, this is a normal phenomenon, and the

condensation can be wiped away with a dry towel.

◆Airflow sound: Refrigerants circulating in the refrigerant lines will produce eruption of sound and

grunts which is normal does not affect the cooling effect.

◆Buzz: Buzz will be generated by running compressor specially when starting up or shutting down.

◆Clatter: The solenoid valve or electric switch valve will clatter which is a normal phenomenon and

does not affect the operation.

Transient difficulty in

door opening

After refrigeration, there will be pressure difference between

the inside and outside of the refrigerator to result in transient

difficulty in door opening. This is a normal physical phenomenon.

Maintenance of freezers

Cleaning

Freezer shall be manually defrosted.

Unplug the freezer and open the freezer door, remove foods and drawers before defrosting;

Open the outflow holes and drainage holes (and place water container at the outflow holes);

indoor frost will naturally melt, wipe the defrost water with a dry, soft cloth. When the frost

softens, an ice scraper might be used to the accelerate de-icing process.

Please remove the food and put in a cool place when defrosting before removing accessories.

Foods can be preserved for a couple of hours even in summer in case of power failure; it is

recommended to reduce the frequency of opening door and do not put fresh foods into the

freezer.

Please unplug the freezer left unused for a long time for cleaning. Keep the door open to avoid

the bad odor.

Do not turn upside, horizontally place or vibrate the freezer, the carrying angle can not be

greater than 45°. Please hold the door and hinge when moving.

Do not use hard brushes, clean steel balls, wire brushes,

abrasives, such as toothpastes, organic solvents (such as

alcohol, acetone, banana oil, etc.), boiling water, acid or

alkaline items clean chest freezer considering that this may

damage the fridge surface and interior.

Do not rinse with water so as not to affect the electrical insulation

properties. Please use a dry cloth when cleaning temperature

control knob and electrical components.

Please unplug the for defrost and cleaning. freezer

Dusts behind the freezer and on the ground shall be timely cleaned to improve the cooling

effect and energy saving. The interior of the freezer should be cleaned regularly to avoid odor.

Soft towels or sponge dipped in water and non-corrosive neutral detergents are suggested for

cleaning. The freezer of shall be finally cleaned with clean water and dry cloth. Open the door for

natural drying before the power is turned on.

Defrost

Other mechanical devices or other means shall not be used to accelerate

except those recommended by the manufacturer. Do not damage the

refrigerant circuit.

Stop using

Continuous operation is recommended when the freezer is

started. Please do not move the freezer under normal

circumstances so as not to affect the freezer's service life.

Energy Conservation

lThe freezer shall be placed in room dry and ventilated. The freezer cannot be put under direct sunlight or

next to hear source (Such as radiator, stove, etc.), and a suitable insulation board shall be applied if

necessary.

lTry to shorten opening time of freezer's door.

lPut beverage into freezer after it has cooled down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edy EDHK7001 Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info