Bedienungsanleitung Efco MT1800 (Seite 31 von 202) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch)

644119

Zoom out

Zoom in

Vorherige Seite

1/202

Nächste Seite

RUS

hand (Fig.11). Chain tension is correct when

it can be lifted approximately 2-4 mm clear

of the guide bar. The chain must be adjusted

so that can be moved freely by hand.

WARNING - The throttle lever must be

pressed before the chain can be rotated.

Check that the power cord is NOT

plugged into the mains socket outlet.

- Fully tighten the chain guard fixing knob

(A, Fig.12) while keeping the tip of the bar

raised.

5. STARTING

OIL FILLING AND CHAIN LUBRICATION

The saw chain is automatically lubricated

during use by a pump which normally requires

no maintenance. The oil flow is pre-regulated

by the manufacturer to ensure a sufficient oil

delivery even under heavy working conditions.

During cutting of thin timber a possible oil

dripping is normal.

- Always wipe off around the filler hole before

unscrewing the cap (A, Fig. 13) so that no dirt

enters the oil reservoir.

- During work watch the oil level (B).

- Add oil whenever the oil level in the reservoir

drops to the notch of the minimum.

- After the filling, operate the motor 2 or 3

times to restore correct oil delivery.

- In case of faults do not try to repair the

machine yourself, but apply to your

authorized dealer.

Correct chain lubrication during the cutting

phase reduces wear to a minimum between the

chain and bar thus prolonging life. Always use a

good quality oil.



WARNING - Never use waste oil.

Always use biodegradable lubrificant

(eco-lube Efco p.n. 001001552 (5) -

001001553 (1)) which is specific for bar and

chain and also respectful towards nature,

operator health and electric saw’s parts.

WARNING - Remove the plug for

connection to the mains before carrying

out any operation on the cutting

equipment.

Before starting make sure the chain is

not obstructed.



When the chainsaw is running, grip the

front handle firmly with your left hand

and the back handle with your right hand

(Fig. 14).

- Stop the motor before setting the chain saw

down.

- Do not lean forward and do not cut above

shoulder height; gripping the saw at the top

of the handle makes it difficult to control and

counteract kickback.

- Do not use in trees or on steps, this is

extremely dangerous.

- Ensure that the cable does not snag on

parts of the tree when the machine is in

operation.

- Stop the saw if the chain strikes a foreign

object. Inspect the saw and repair or replace

parts as necessary.

- Left-handers should follow these

instructions too. Keep a proper cutting

stance.



Over exposure to vibrations can result in

blood-vessel or nerve injury to persons

suffering with blood circulation problems.

Seek medical attention if you experience

physical symptoms such numbness, lack

of feeling, reduction in normal strength,

changes in the colour of the skin. These

symptoms normally appear in the fingers,

hands or wrists.

CONNECTION TO THE NETWORK



WARNING - Before connecting the plug

to the network check that the voltage

corresponds to the technical data shown below.

Verify that the dimensions of the extension

cable are according to the specifications,

otherwise a drop in tension may occur causing

a consequent irreparable damage to the motor.

The earth plate is not necessary since the

electric saw motor is double insulated.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Efco MT1800 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info