14
GB
4. Technical data
Idle speed n
0
3.200 min
-1
Cutting width: 330 mm
Debris bag volume 27 liters
Cutting height adjustment 38-78 mm; 4 levels
Protection type IP24
Vibration a
hv
≤ 2.5 m/s
2
Battery operating time max. 38 min
Charging time 10-12 h
L
WA
sound power level 96 dB
L
pA
sound pressure level 71 dB
Lead battery
Voltage 24 V DC
Capacity 10 Ah
Battery charger
Output voltage 24 V DC
Output current 1 A
5. Before starting the equipment
The lawn mower is delivered unassembled. The
complete push bar and the grass basket must be
assembled before using the lawn mower. Follow the
operating instructions step-by-step and use the
pictures provided as a visual guide to easily assemble
the machine.
Fitting the push bar (Fig. 3a to 3d)
Take the bottom push bar and insert them into the
two respective openings (Fig. 3a). Attach the push
bar brackets as shown in Figure 3b, using the screws
provided (Fig. 2/Item 11). Secure the top push bar
and the bottom push bar using the star nuts (Fig.
2/Item 9) and screws (Fig. 2/Item 10) as shown in
Figure 3c. Then attach the power cable to the push
bar (Fig. 3d) using the cable clips (Fig. 2/Item 12).
Fitting the grass box (Fig. 3e)
Before you fit the grass bag you must ensure that the
motor is switched off and the blade is not rotating. Lift
the ejector flap (Fig. 3e/Item 5) with one hand. With
the other hand, hold the grass bag by the handle and
hook it in from above (Fig. 3e).
Adjusting the cutting height
Important. Adjust the cutting height only when the
engine is switched off and the power cable has been
disconnected.
Before you begin to mow, check to ensure that the
blade is not blunt and that none of the fasteners are
damaged. To prevent any imbalance, replace blunt
and/or damaged blades. To carry out this check, first
switch off the motor and pull out the power plug.
The cutting height is adjusted as shown in Figure 6.
To do so, turn the equipment upside down or tilt it to
the side. Position both the front and rear axle in the
same notch, so that the cutting blade runs parallel to
the lawn.
Position K
Cutting depth: 78 mm
Position L
Cutting depth: 63 mm
Position M
Cutting depth: 50 mm
Position N
Cutting depth: 38 mm
Battery
The device is fitted with a lead battery. The lead
battery pack is completely closed and maintenance
free.
Battery charge level indicator (Fig. 5a)
The battery pack is equipped with 3 LEDs which
show the charge level of the battery pack during
operation.
Green LED (Fig. 5a/Pos. C): Battery charge level
high.
Yellow LED (Fig. 5a/Pos. D): Battery charge level
decreasing. Stop work as soon as possible.
Red LED (Fig. 5a/Pos. E): Battery nearly empty.
Stop work IMMEDIATELY and charge the battery.
Otherwise the battery’s service life will be greatly
shortened.
If no LED lights up, the battery pack is not inserted
correctly. Remove the battery pack and insert
correctly.
