Bedienungsanleitung Einhell BH2000 (Seite 6 von 24) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

461621

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

the minimum distance to the housing, or the

installation height, has to be measured from the

top of the skirting.

 Then drill the two fastening holes with 6 mm

diameter. The centers of the holes must be

marked so that they are 167 mm apart and

horizontal (Fig 2) and at least 1500 mm above

the floor (allow for skirtings) and the holes drilled

accordingly.

 Insert wall plugs in the drilled holes, screw in the

screws and hang the heater on the wall.

4. Technical data:

Rated voltage: 230 V ~ 50 Hz

Output: 1600 W (800 W / 1600 W)

Protection type: IP24

Appliance dimensions, approx.: 27 x 13 x 37 cm

5. Proper use

The appliance is designed only for private use, not

for commercial heating purposes.

6. Starting up

Important! Before using the appliance for the first

time, check that the voltage supply is the same as

the voltage details set out on the data plate. Read

safety instructions listed under section 1.

When the heater is used for the first time or after a

long period of rest it may emit an odor for a short

time. This is not a fault.

6.1 Switch for heat output (Fig. 1 / Item 1)

Important!

The switch is to be operated only in anticlockwise

direction.

 Off setting (0)

 Fan setting (1)

 Low heating output (2) 800 W

 Maximum heating output (3) 1600 W

The switch can also be actuated with the pull cord

(Fig. 1/Item 4).

6.2 Overheat cut-out

In case of excessive heating, the heating function

shuts down automatically. If this case occurs, turn off

the appliance, disconnect the mains plug and wait a

few minutes until it has cooled. After eliminating the

cause (e.g. a covered air grille), the appliance can be

switched on again. If the overheat cut-out triggers

repeatedly, please contact your customer service

center.

7. Maintenance and cleaning

 Before carrying out any cleaning and maintenance

work the appliance must be turned off,

disconnected from the power supply and cooled

down.

 Maintenance and repair work may only be carried

out by an electrical servicing contractor or your

customer service center.

 Check the mains lead at regular intervals for signs

of defects or damage. A damaged mains lead may

only be replaced by an electrician or the customer

service responsible for your country in compliance

with the relevant regulations.

 Use a damp cloth to clean the casing.

 Remove dust pollution with a vacuum cleaner.

8. Storage

The radiator has to be stored in a dry place, covered

if possible.

9. Ordering spare parts

Please provide the following information on all orders

for spare parts:

 Model/type of machine

 Article number of the machine

 ID number of the machine

 Number of the required spare part

For our latest prices and information please go to

www.isc-gmbh.info

Anleitung BH 2000_SPK1 16.08.2006 15:26 Uhr Seite 6

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Einhell BH2000 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info