Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Safety regulations
Never use an axle stand that is defective or
damaged. Check the welds and rivet joints every
time before use.
Make yourself familiar with the equipment and
the folding mechanism before using for the first
time. Ensure that you insert the locking pins
correctly.
It is essential that you obey the safety
instructions for the jack.
The axle stand may only be used on a firm, flat
surface.
After you have chocked the vehicle to prevent it
rolling away and jacked it up, you must support it
as quickly as possible with at least one axle
stand.
Always lower the vehicle slowly and carefully on
to the axle stand.
An axle stand positioned at an angle can slip out
or break.
Ensure that the support area is positioned
correctly on the support point of the vehicle
chassis. The support points are described in the
handbook supplied with the vehicle.
The height adjustment bolt must always be
secured with a pin when there is a load on the
axle stand.
Check the stability of the axle stand before
starting work on the vehicle.
Do not exceed the load capacity of the axle
stand.
Never use four axle stands on a single vehicle.
Never use a jack on one end of the vehicle if the
other end is already jacked up.
Never use the axle stand for three-wheeled
vehicles or trailers.
Always use axle stands in pairs.
2. Layout (Fig. 1)
1. Folding foot
2. Split pin for retaining pin
3. Center column
4. Support area
5. Retaining pin
6. Center tube
7. Split pin for folding mechanism
8. Folding mechanism
3. Intended use
The axle stands are designed only for supporting
motor vehicles. Check the maximum load capacity
(see technical data) and do not exceed it
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
BT-AS 2000
Load capacity (kg) 2000 kg
Min. height (mm) 277 mm
Max. height (mm) 365 mm
BT-AS 3000
Load capacity (kg) 3000 kg
Min. height (mm) 285 mm
Max. height (mm) 400 mm
BT-AS 6000
Load capacity (kg) 6000 kg
Min. height (mm) 376 mm
Max. height (mm) 576 mm
5
GB
