11
GB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Chiseling
Vibration emission value a
h
= 16.29 m/s
2
K uncertainty = 1.5 m/s
2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
n Only use appliances which are in perfect working
order.
n Service and clean the appliance regularly.
n Adapt your working style to suit the appliance.
n Do not overload the appliance.
n Have the appliance serviced whenever
necessary.
n Switch the appliance off when it is not in use.
n Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
5.1 Additional handle (Fig. 2)
For safety reasons you must only use the
demolition hammer with the additional handle.
The additional handle (3) enables you to achieve
better stability whilst using the demolition hammer.
The additional handle (3) can be turned into any
required position. Undo the screw (a) by turning it in
the “+” direction. Now turn the additional handle (3)
into the most comfortable working position for
yourself and then tighten the screw (a) again by
turning it in the “-” direction.
5.2 Inserting the tool (Fig. 3-4)
n Clean the tool before fitting it and apply a thin
coating of grease to the tool shaft.
n Pull out the locking bolt (4) as far as possible, turn
it through 180° and release it.
n Insert the tool into the tool mounting (5) and push
it in as far as possible. (see Fig. 3)
n Pull out the locking bolt (4) again, turn it through
180° in the opposite direction and release it.
n Check the lock by pulling the tool.
5.3 Removing the tool
To remove the tool, proceed in reverse order.
6. Starting up
Important.
To avoid danger, the machine must only be held
using the two handles (1/3). Otherwise you may
suffer an electric shock if you chisel into cables.
6.1 Switching on and off (Fig. 5)
To switch on:
Press the control switch (2).
To switch off:
Release the control switch (2).
