11
GB
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
There is a risk of staples becoming jammed
particularly when the electric stapler is held at any
angle when operated. In this case, switch the tool off
immediately and pull the power plug.
Important. Always pull the plug out of the
power socket before doing any work on the
electric stapler!
Removing jammed staples (Fig. 2/3/7)
Pull the magazine slide (4) toward the rear of the
electric stapler (Fig. 2/3) and out. Undo both screws
on the stapler head (7) with an Allen key as shown
in Fig. 7. Lift off the metal cover and carefully
remove the jammed staples with a suitable pair of
pliers. Then refasten the metal with the two Allen
screws. Push the magazine slide (4) back in until it
stops and snaps noticeably into place.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
9. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
