try to start the engine. Do not attempt to start the
vehicle for longer than 5 seconds because of the
very high current involved.
5. First disconnect the pole clamp from the
vehicle’s earthing strip (negative pole).
6. Then disconnect the jumper cable from the
POSITIVE pole (+) of the vehicle battery.
7. The energy station will need to be recharged
after giving this starting aid.
9. Battery status monitoring
The voltage meter (Fig. 1/Item 5) keeps you
constantly informed as to the charge status of the
battery.
Its indicator responds when you actuate the
pushbutton (Fig. 1/Item 4).
Green
The battery is 50 - 100 % full.
Yellow
The battery is 0 - 50 % full and should be recharged.
Red
The battery is completely run down. The battery can
reach this state after jump starting a vehicle, for
example. The battery must be recharged.
Continuing to operate the unit from this point may
damage the battery.
10.Replacing the lamp
Important! The lamp must be switched off.
Proceed as follows to replace the lamp.
1. Using both hands, squeeze the lamp cover
(Fig. 1/Item 6) together slightly from the sides,
then pull the cover off.
2. Turn the lamp socket anti-clockwise.
3. Replace the lamp with the same style of bulb
(i.e. 12 V/0.3 A).
4. To install the new lamp, proceed in reverse
order.
5. Snap the light cover (Fig. 1/Item 6) back on.
11. 12-volt compressor
11.1 Filling tires
Note! Use a tire pressure gauge to check the actual
tire pressure at the nozzle. Observe the information
in the vehicle’s owner manual concerning the filling
of tires.
The equipment’s pressure gauge is not calibrated.
The indicated values are not guaranteed exact air
pressure values.
1. Remove the valve cap from the valve.
2. Push the connector piece of the compressor all
the way down over the valve (Fig. 2/Item 1).
3. Secure the connector piece by flipping back the
locking lever on top of the connector (Fig. 2/Item
2).
11.2 Filling air mattresses, etc.
Important! Because of the material composition of
air mattresses, rubber rafts, etc., obtaining an exact
air pressure read-out is not possible. Therefore, pay
special attention to ensure that you do not overfill
these objects, as they will burst! It is imperative that
you observe the specifications issued by the
manufacturer of the inflatable article.
쐌 Select the appropriate adapter and insert it into
the connector piece of the air hose.
Adapter 1 (Fig. 3/Item 1): for air mattresses
Adapter 2 (Fig. 3/Item 2): for sporting balls
Adapter 3 (Fig. 3/Item 3): for beach balls
쐌 Secure the connector piece by flipping back the
locking lever on top of the connector (Fig. 2/Item
2).
11.3 Starting up the compressor
Important! Please read the bulleted items listed
under „1. Important Notes“ prior to starting up the
compressor. Ensure that the compressor cools
down for 15 minutes after it has run for 10 minutes.
쐌 Check the pressure gauge (Fig. 4/Item 10) prior
to switching on.
쐌 To switch on, flip the ON/OFF switch
(Fig. 4/Item 11) to „I“.
쐌 To switch off, flip the ON/OFF switch
(Fig. 4/Item 11) to „0“.
16
GB
