14
GB
service workshop.
This tool complies with the pertinent safety
regulations. Repairs are to be carried out only by
qualified electricians using original replacement
parts. The user may suffer an accident if this
condition is not observed.
Be careful when making vertical cuts.
Take special care when making double miter
cuts.
Do not overload the tool!
Wear safety goggles.
Use a breathing mask on dusty jobs.
Check the tool’s power cable / extension cable
for damage.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Important!
Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open the laser module.
When the device is not going to be used for
an extended period of time, the batteries should
be removed.
Noise emission values
The saw’s noise is measured in accordance with
DIN EN ISO 3744; 11/95, E Din EN 31201; 6/93,
ISO 7960 Annex A; 2/95. The machine may
exceed 85 dB(A) at the workplace. In this case,
noise protection measures need to be introduced
for the user (ear-muffs).
Idle speed
Sound pressure level LPA 91,4 dB(A)
Sound power level LWA 104,4 dB(A)
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
at the workplace include the duration of impact, the
type of room, and other sources of noise etc., e.g.
the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.“
5. Technical data
Asynchronous motor 230 V~ 50 Hz
Output 2000 W
Operating mode S1
Idle speed n
0
4800 min
-1
Carbide-tipped saw blade ø 250 x ø 30 x 3,0 mm
Number of teeth 60
Tilting range -45° / 0°/ +60°
Mitre cuts 0° to 45° to the left
Sawing width at 90° 430 x 75 mm
Sawing width at 45° 300 x 75 mm
Sawing width at 2 x 45°
(double mitre cuts) 300 x 40 mm
Weight 18 kg
Laser class 2
Laser wave length 650 nm
Laser output ≤ 1 mW
Laser module power supply 2 x 1.5 V Micro (AAA)
