GB
18
Specifications
MT 24 MTK 24
Engine Type Air-cooled, 2-Cycle, Chrome Cylinder Air-cooled, 2-Cycle, Chrome Cylinder
Displacement 24 cm
3
24 cm
3
Power: 0,6 kW 0,6 kW
Dry Weight 4,5 kg 4,8 kg
Fuel Capacity 500 ml 500 ml
Drive Shaft Length 112 cm 122 cm
Cutting Width 38 cm 38 cm
Handle Adjustable Adjustable
Ignition Electronic Electronic
Drive Centrifugal Clutch Direct Drive
Nylon cutting line ø 2,0 mm 2,0 mm
Assembly instructions
• Handle Assembly
NOTE: The Handle is attached to the shaft but has
beened turned under for ease of packing.
1. Loosen adjustment knob and rotate handle to top
of shaft. Position handle 160mm - 220mm from
throttle (Fig. 1b).
2. Tighten adjustment knob securely.
• DEBRIS SHIELD (Fig. 2A - 2B)
Warning: The debris shield must be installed to
properly dispense cutter line and protect operator.
Shield fits snug on shaft. Some force may be
required.
1. Seat shield (B) onto shaft bracket (C).
2. Insert washers (D) onto bolt.
3. Insert bolt (E) and nut (F), tighten securely.
• Drive shaft (MTK 24 only)
Installing the lower shaft
1. Remove the hanger from the lower shaft (A).
Press the release lever (B) while pushing the
lower shaft into the tool-link couping. (Fig. 3A)
2. Locate and lock the release lever into the primary
hole (C) in the shaft. (Fig. 3A)
CAUTION: Make sure the release lever is locked
in the primary hole and knob is securely tightened
before operating this unit.
3. Tighten the knob (D) securely clockwise before
using the unit. (Fig. 3B)
CAUTION: If the incorrect hole is used, it could
result in injury, or damage to the unit.
Fuel and lubrication
• Fuel
Use regular grade unleaded gasoline mixed with 2-
cycle engine oil for best results. Use mixing ratios in
Section FUEL MIXING TABLE.
Warning: Never use straight gasoline in your
unit. This will cause permanent engine damage and
void the manufacturer’s warranty for that product.
Never use a fuel mixture that has been stored for
over 90 days.
Warning: Do not use any 2-cycle oil product with
a recommended mixing ratio of 100:1. If insufficient
lubrication is the cause of engine damage, it voids
the manufacturer’s engine warranty.
• MIXING FUEL
Mix fuel 2 cycle oil in an approved container. Use
mixing table for correct ratio of fuel to oil. Shake
container to ensure through mix.
Warning: Lack of lubrication voids engine
warranty. Gasoline and oil must be mixed at 25:1.
Anleitung_MT24-MTK24 21.11.2002 8:40 Uhr Seite 18
