Bedienungsanleitung EK63-EdilKamin DORE160 H (Seite 12 von 28) (Englisch)

810941

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

INSTALLATION

THE FLUE

THE FLUE:

Further to the general prescriptions for the fumes

duct and ﬂ ue, the ﬂ ue

• must serve solely to exhaust fumes

• must be correctly sized to satisfy the requirements

of fumes exhaust (EN 13384-1)

• must preferably be insulated, in steel with a

circular internal section. If rectangular, the

corners must have a radius of not less than 20

mm, with a ratio of the internal dimensions of

<1.5

• must normally be at least 1.5 metres in vertical

length

• must have a constant cross section

• must be waterproof and thermally insulated to

ensure a good draw

• must preferable have a collection chamber for

uncombusted matter and condensation

• if pre-existing, must be clean, to prevent the ﬁ re

hazard

• in general, we recommend ﬁ tting a tube inside

the existing masonry chimney if its diameter is

greater than 150 mm.

INTUBATED SYSTEM

INTUBATED SYSTEM:

Further to the general prescriptions for the fumes

duct and ﬂ ue, the intubated system:

• must operate in negative pressure

• must be open to inspection

• must observe local regulations.

THE CHIMNEY POT

• must be windproof

• must have an internal cross section equivalent to

that of the ﬂ ue and a fumes outlet at least double

that of the interior of the ﬂ ue

• for dual ﬂ ues (which should be spaced at least

2 m apart) the chimney pot receiving the fumes

from the solid fuel appliance or that from the

higher storey, must be at least 50 cm higher than

the other

• it must extend beyond the back ﬂ ow zone (in

Italy, refer to UNI 10683 point 6.5.8.)

• it must allow for maintenance of the chimney

EXTERNAL AIR INTAKE

In general, we suggest two ways to ensure a proper

ﬂ ow of combustion air.

Indirect air intake

Install an air outlet at ﬂ oor level with an eﬀ ective

surface area (net of the screen or other protections)

of at least 80 cm2 (10 cm in diameter).

To prevent draughts, we recommend installing the

intake behind the boiler stove or behind a radiator.

Installing it in front of the appliance will create

unpleasant draughts.

Direct air intake

Install an air intake of eﬀ ective area ((net of the mesh

or other protective equipment) at least equal to that of

the air intake at the back of the product.

Connect the air intake to the appliance's air intake

with a tube (which may also be ﬂ exible).

The air may be drawn from an adjacent room only if:

• the ﬂ ow is taken from permanent and unobstructed

openings communicating with the outdoors;

• the adjacent room is never in underpressure

relative to the outdoors;

• the adjacent room is not a garage. subject to ﬁ re

hazard, a bathroom or bedroom;

• the adjacent room is not a shared room in the

condominium.

In Italy, UNI 10683 provides that ventilation is

suﬃ cient even if a pressure diﬀ erence between

the outdoors and indoors of no more than 4 PA is

guaranteed (UNI EN 13384-1). The installer who

issues the declaration of conformity is responsible for

ensuring these conditions.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

EK63-EdilKamin DORE160 H Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von EK63-EdilKamin DORE160 H

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info